Maintenance
•WARNING
Disconnect from the mains electricity supply, before attempting any maintenance or adjust- ment. Cutting head continues to rotate after the trimmer has been switched off. Keep fingers and hands clear of the line cutter on leading edge of guard.
Caring for your Contour Power Plus
After you have finished using your Flymo Contour Power Plus follow the procedure below:
AVOID ACCIDENTAL STARTING. REMOVE PLUG FROM MAINS AND KEEP FEET AWAY FROM THE SWITCH LEVER WHEN: CLEANING AROUND THE INSIDE OF THE SAFETY GUARD, REMOVING OR REFITTING SPOOL CAP, MANUALLY FEEDING OR REPLACING NYLON LINE.
1.Disconnect from the mains electricity supply.
2.Never clean your trimmer with water, cleaning fluids, or solvents, just remove debris with a suitable tool, a soft brush or dry cloth.
3.Using a soft brush, clean around the inside of the safety guard, the cutting head (Fig S) and the motor housing air vents. (Fig T)
4.Remove the wheel by pressing one of the buttons.
Clean the wheel and groove on trimmer head with a soft brush (V & W).
5.Attach wheel as described in Wheel Assembly.
6.Inspect the trimmer carefully, especially the parts of the cutting head.
7.If your trimmer is damaged in any way contact your local Electrolux Outdoor Products approved service
centre.
•Never use a damaged trimmer.
8.Store in a cool, dry place and out of reach of chil- dren.
Cable Storage
1.Your mains cable can be stored on the product as illustrated in Fig X.
2.Wind cable carefully to avoid kinking.
3.To release the cable press the button and the hook will drop down (Fig Y).
4.Push cable hook fully back into position.
S
T
V
W | X |
Y |
|