SDo not swing unit with such force that you are in danger of losing your balance.
Bring the engine to cutting speed before enter- ing the material to be cut.If the blade does not turn when you squeeze the throttle trigger, make sure shaft is fully inserted into the engine.
Always release the throttle trigger and allow engine to return to idle speed when not cut- ting. The blade should not turn while the en- gine is running at idle. If the blade turns at idle, do not use your unit. Refer to the CARBURE- TOR ADJUSTMENT section or contact your authorized service dealer.
SMaintain good firm footing while using the
unit. Do this by planting feet firmly in a comfortable apart position.
SCut while swinging the upper part of your body from left to right.
SAs you move forward to the next area to cut, be sure to maintain your balance and footing.
RECOMMENDED CUTTING POSITION
| 2 o’clock |
Cut using the 2 |
|
o’clock to 4 o’clock | 4 o’clock |
position of the | |
blade |
|
WARNING: The operator or others must not try to clear away cut material with the engine running or the blade turning to avoid serious injury. Stop engine and blade before removing materials wrapped around blade or shaft.
ADDITIONAL SAFETY RULES
FOR OPTIONAL ATTACHMENTS
WARNING: For each optional at- tachment used, read entire instruction manu- al before use and follow all warnings and in- structions in manual and on attachment.
WARNING: Ensure handlebar re- mains installed on upper shaft (engine end of unit) at all times.
Handlebar
EDGER SAFETY
WARNING: Inspect the area to be edged before each use. Remove objects (rocks, broken glass, nails, wire, etc.) which can be thrown by the blade or can wrap around the shaft.
SBlade rotates momentarily after the trigger is released. The blade can seriously cut you or others.
SAllow blade to stop before removing it from the cut.
SThrow away blades that are bent, warped,
cracked, broken or damaged in any other way. Replace parts that are cracked, chipped, or damaged before using the unit.
S Do not attempt to remove cut material nor hold material to be cut when the engine is running or when cutting blade is moving.
SAlways keep the wheel and depth adjusting skid in contact with the ground.
S Always push the unit slowly over the ground. Stay alert for uneven sidewalks, holes in the terrain, large roots, etc.
S Always use the handlebar when using edger attachment.
BLOWER/VACUUM SAFETY
WARNING: Inspect area before starting unit. Remove all debris and hard ob- jects such as rocks, glass, wire, etc. that can ricochet, be thrown, or otherwise cause injury or damage during operation.
SDo not set unit on any surface except a clean, hard area while engine is running. Debris such as gravel, sand, dust, grass, etc., could
be picked up by the air intake and thrown out through discharge opening, damaging unit, property, or causing serious injury to bystanders or operator.
SNever place objects inside the blower tubes, vacuum tubes or blower outlet. Always direct the blowing debris away from people, animals, glass, and solid objects such as trees, automobiles, walls, etc. The force of air can cause rocks, dirt, or sticks to be thrown or
to ricochet which can hurt people or animals, break glass, or cause other damage.
S Never run unit without the proper equipment attached. When using your unit as a blower, always install blower tubes.
SCheck air intake opening, blower tubes or vacuum tubes frequently, always with engine stopped and spark plug disconnected. Keep vents and discharge tubes free of debris which can accumulate
and restrict proper air flow.
SNever place any object in air intake opening as this could restrict proper air flow and cause damage to the unit.
SNever use for spreading chemicals, fertilizers, or other substances which may contain toxic materials.
STo avoid spreading fire, do not use near leaf or brush fires, fireplaces, barbecue pits, ashtrays, etc.
12