Poulan 545137278 instruction manual Seasonal Storage, Fuel System, Engine, Other

Page 17

STORAGE

WARNING: Perform the following steps after each use:

SAllow engine to cool before storing or trans- porting.

SStore unit and fuel in a well ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric

motors or switches, furnaces, etc.

SStore unit with all guards in place. Position unit so that any sharp object cannot acci-

dentally cause injury.

SStore unit and fuel well out of the reach of children.

SEASONAL STORAGE

Prepare unit for storage at end of season or if it will not be used for 30 days or more.

If your unit is to be stored for a period of time: S Clean the entire unit before lengthy

storage.

SStore in a clean dry area.

SLightly oil external metal surfaces.

FUEL SYSTEM

Under FUELING ENGINE in the OPERA- TION section of this manual, see message la- beled IMPORTANT regarding the use of ga- sohol in your engine.

Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to the gasoline in the fuel tank or fuel storage container. Fol- low the mix instructions found on stabilizer container. Run engine at least 5 minutes after adding stabilizer.

HELPFUL TIP

During storage of your gas/ oil mixture, the oil will sepa- rate from the gas.

We recommend that you shake the gas can weekly to insure proper blending of the gas and oil.

ENGINE

SRemove spark plug and pour 1 teaspoon of 40:1, 2-cycle engine oil (air cooled) through

the spark plug opening. Slowly pull the starter rope 8 to 10 times to distribute oil.

SReplace spark plug with new one of recom-

mended type and heat range.

SClean air filter.

S Check entire unit for loose screws, nuts, and bolts. Replace any damaged, broken, or worn parts.

SAt the beginning of the next season, use only fresh fuel having the proper gasoline to oil ratio.

OTHER

SDo not store gasoline from one season to another.

SReplace your gasoline can if it starts to rust.

17

Image 17
Contents Manual de Instrucciones Manuel d’Instructions Always Wear Safety RulesOperator Safety Fuel Safety UNIT/MAINTENANCE SafetyCutting Safety Transporting and StorageCarton Contents AssemblyInstalling Brushcutter Attachment Tools RequiredConfiguring Your Unit Assembly of Shoulder StrapAssembly Information Trimmer Head To Relocate Shoulder Strap ClampAttaching the Plastic Shield and Trimmer Head Assembly Information Weed BladeAttaching the Metal Shield Weed BladeWasher Cupped Nut Installation of the Metal BladeOperation HOW to Start Your Unit HOW to Stop Your UnitStarting a Cold Engine Starting a Warm EngineOperating Position Installing Optional ATTACH- MentsOperating Instructions for USE with Trimmer Head Cutting MethodsMum line wear by not crowding the line into Operating Instructions for USE with Weed BladeCutting area. The right and wrong ways Inches 8 cm above groundEdger Safety Additional Safety RulesBLOWER/VACUUM Safety Recommended Cutting PositionPole Pruner Safety Cultivator SafetyHedge Trimmer Safety Snow Thrower Safety Maintenance Blade Replacement Service and AdjustmentsCarburetor Adjustment Replacing the LineFuel System Seasonal StorageEngine OtherTroubleshooting Table Cause Remedy Ligations The U.S. Environmental Limited Warranty800--554--6723 ServicePRO