Poulan 545177328 instruction manual Operation

Page 9

For proper orientation of shield, see KNOW YOUR TRIMMER illustration in OPERATION section.

1.Remove wing nut from shield.

2.Insert bracket into slot as shown.

3.Pivot shield until bolt passes through hole in bracket.

4.Securely tighten wing nut onto bolt.

Locking/Release Button in Primary Hole

Bracket

Slot

Wing Nut

For assembly of optional attachments (see list on page 11), refer to the ASSEMBLY sec- tion of the applicable attachment instruction manual.

ATTACHING THE SHIELD

Shield

Gearbox

WARNING: The shield must be prop- erly installed. The shield provides partial protec- tion from the risk of thrown objects to the opera- tor and others and is equipped with a line limiter blade which cuts excess line to the proper length. The line limiter blade (on underside of shield) is sharp and can cut you.

ADJUSTING THE HANDLE

WARNING: When adjusting the han- dle, be sure it remains above the safety label and below the mark or arrow on the shaft.

1.Loosen wing nut on handle.

2.Rotate the handle on the shaft to an up- right position; retighten wing nut.

OPERATION

KNOW YOUR UNIT

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.

Muffler

 

Assist Handle

 

Coupler

 

Trimmer

Shaft

 

Head

Spark

Throttle Trigger

 

 

Plug

 

 

Shield

Primer Bulb

 

 

Line Limiter

 

Start

 

Lever

Blade

ON/STOP

 

 

 

 

Switch

Starter handle

 

 

ON/STOP SWITCH

The ON/STOP switch is located on the trigger handle and is used to stop the engine. To stop the engine, push and release the engine ON/STOP switch.

PRIMER BULB

The PRIMER BULB removes air from the car- buretor and fuel lines and fills them with fuel. This allows you to start the engine with fewer pulls on the starter rope. Activate the primer bulb by pressing it and allowing it to return to its original form.

9

Image 9
Contents English Español Français Manual de Instrucciones Manuel d’InstructionsHazard zone for thrown objects Identification of Safety SymbolsOptional Attachments Operator Safety Safety RulesUnit / Maintenance Safety Fuel SafetyAdditional Safety Rules Line Trimmer SafetyEdger Safety BLOWER/VACUUM SafetyCultivator Safety Brushcutter SafetyBreak glass, or cause other damage Damage to the unitHedge Trimmer Safety Pole Pruner SafetySnow Thrower Safety Installing Trimmer ATTACH- Ment AssemblyOperation HOW to Stop Your Unit HOW to Start Your UnitStart Lever CouplerStarting a Warm Engine Installing Optional ATTACH- MentsStarting a Flooded Engine Operating the CouplerOperating Position Trimmer Line AdvanceCutting Methods Inspect and Clean Unit and DE- Cals MaintenanceClean AIR Filter Check for Loose Fasteners and PartsInspect Muffler and Spark Arresting Screen Service and AdjustmentsReplace Spark Plug Replacing the LineStorage Carburetor Idle Speed AdjustmentSeasonal Storage Fuel SystemOther Troubleshooting Table Cause RemedyAnother Do not store gasoline from one season toLimited Warranty Canada, contactLigations The U.S. Environmental Ty@HCOP--emission.com. Mainte NANCE, Replacement and Repair