Poulan BVM210VS instruction manual Operation

Page 7

OPERATION

KNOW YOUR BLOWER

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.

Upper Vacuum Tube

Elbow Tube

 

Lower Vacuum Tube

 

Starter

Rope

Fuel Mix

Fill Cap

Primer

Button

STOP

Vacuum Bag

Throttle Switch

 

Trigger

Spark

 

Plug

 

Upper Blower Tube

 

Lower Blower Tube

High--Speed

Nozzle

Start Lever

Vacuum Handle

STOP SWITCH

The STOP switch is used to stop the engine. To stop the engine, push and hold the STOP switch in the STOP position until the engine stops.

THROTTLE TRIGGER

The THROTTLE TRIGGER is used to select the desired engine speed.

PRIMER BUTTON

The PRIMER BUTTON removes air from the carburetor and fuel lines and fills them with fuel. This allows you to start the engine with fewer

pulls on the starter rope. Activate primer button by pressing it and allowing it to return to its origi- nal position.

START LEVER

The START LEVER helps to supply fuel to the engine to aid in starting. Activate the starting system by moving the start lever to the START position. DO NOT squeeze the throttle trigger until the engine has started and runs. After the engine starts, allow the engine to warm--up 10--15 seconds, then fully squeeze the throttle trigger to deactivate the starting system.

OPERATING POSITION

BlowerVacuum

OPERATING TIPS

S While vacuuming or blowing debris, hold the unit with the muffler side facing away from your body and clothes (see OPERAT- ING POSITION illustration above).

S To reduce the risk of hearing loss associated with sound level(s), hearing protection is required.

STo reduce the risk of injury associated with contacting rotating parts, stop the engine be- fore installing or removing attachments. Do

not operate without guard(s) in place.

SOperate power equipment only at reasonable hours--not early in the morning or late at night when people might be disturbed. Comply with times listed in local ordinances. Usual recom- mendations are 9:00 a.m. to 5:00 p.m.,

Monday though Saturday.

STo reduce noise levels, limit the number of

pieces of equipment used at any one time. S To reduce noise levels, operate power blowers at the lowest possible throttle

speed to do the job.

SUse rakes and brooms to loosen debris be- fore blowing.

--7 --

Image 7
Contents English Español Français Manual de Instrucciones Manuel d’InstructionsIdentification of Safety Symbols Handle Fuel with CAUTION, IT is Highly Flammable Safety RulesKnow Your Unit Plan AheadMaintain Your Unit Properly Operate Your Unit SafelyStore in a dry area out of reach of children Vacuum BAG Assembly AssemblyBlower Tube Assembly HIGH-SPEED Nozzle AssemblyShoulder Strap Adjustment HOW to Convert Unit from Vacuum USE to Blower USEOutlet Latch Area Vacuum Inlet Cover Operation Fuel Requirements HOW to Stop Your EngineHOW to Start Your Engine Before Starting Engine Fueling EngineMaintenance Check Muffler Mounting Screws Carburetor Idle Speed AdjustmentReplace Spark Plug Replace Fuel FilterEngine StorageSeasonal Storage Fuel SystemAdjustment Service and Adjustments Section Troubleshooting Table Cause RemedyCanada, contact Limited WarrantyNANCE, Replacement and Repair