Troy-Bilt TB3000 manual Service Information, Accessory 181696 Spark Arrestor Kit

Page 3

Service Information

SERVICE INFORMATION

Service on this unit both within and after the warranty period should be performed only by an authorized and approved service dealer.

Dial:

1-800-345-8746for authorized service dealers in the United States Or

1-800-668-1238in Canada to obtain the listing of the authorized service dealer nearest you.

DO NOT RETURN THE UNIT TO THE RETAILER.

NOTE: PROOF OF PURCHASE WILL BE REQUIRED FOR WARRANTY SERVICE.

Make sure this manual is carefully read and understood before starting or operating this equipment.

THIS PRODUCT IS COVERED BY ONE OR MORE US PATENTS, OTHER PATENTS PENDING.

WARNING: Engine Exhaust, some of its constituents, and certain vehicle components contain or

emit chemicals known to State of California to cause cancer and birth defects or other reproductive harm.

SPARK ARRESTER INFORMATION

NOTE: For users on U.S. Forest Land and in the states of California, Maine, Oregon and Washington. All U.S. Forest Land and the state of California (Public Resources Codes 4442 and 4443), Oregon and Washington require, by law that certain internal combustion engines operated on forest brush and/or grass-covered areas be equipped with a spark arrestor, maintained in effective working order, or the engine be constructed, equipped and maintained for the prevention of fire. Check with your state or local authorities for regulations pertaining to these requirements. Failure to follow these requirements could subject you to liability or a fine. This unit is factory equipped with a spark arrestor. If it requires replacement, ask your LOCAL SERVICE dealer to install the

Accessory Part #181696 Spark Arrestor Kit.

Identification Numbers

Before you start assembling your new equipment, please locate the model plate on the unit and copy the information from it to the space provided below. The information on the model plate is very important if you need help from our Customer Support Department or an authorized dealer.

You can locate the model number on the shaft housing of the unit next to the On/Off Stop Control Switch. A sample model plate is explained below. For future reference, please copy the model number and the serial number of the equipment in the space below.

Copy the model / parent part number here:

Copy the serial number here:

3

Image 3
Contents Owner/Operator Manual Cycle Trimmer Introduction Table of ContentsAccessory 181696 Spark Arrestor Kit Service InformationBefore Operating SafetySymbol Meaning Safety Warnings for GAS TrimmersOther Safety Warnings While OperatingOperation Unleaded Fuel Safety and International SymbolsSymbol Meaning Safety Alert Symbol For Service INFORMATION, CallTRIMMER/BRUSHCUTTER Safety Symbol Meaning Sharp Blade Choke ControlApplications Know Your UnitInstalling and Adjusting the D-HANDLE AssemblyDefinition of Blended Fuels Using Blended FuelsUsing Fuel Additives Oil and FuelOperation Starting InstructionsStopping Instructions Adjusting Trimming Line Length Holding the TrimmerTips for Best Trimming Results Maintenance Schedule When Maintenance Needed GO toDecorative Trimming Line Installation Go To for Membrane Line InstallationWinding the Existing Inner Reel Replacement Parts See Accessories / Replacement Parts on Installing a Prewound ReelClean Air Filter AIR Filter MaintenanceCarburetor Adjustment Cleaning the Air FilterReplacing the Spark Plug Long Term Storage ACCESSORIES/REPLACEMENT PartsCleaning StorageU S EA C T I O N U S ET I O N U S E T I O NEngine SpecificationsPage MTD Southwest Inc