Lexicon CX manual Basic Operation, Front Panel Overview, Standby Button

Page 10

Basic Operation

Lexicon

FRONT PANEL OVERVIEW

1

1. Standby Button

Activates and deactivates standby mode when the CX amplifi- er is powered on with the rear panel power switch. The stand- by button performs no function when the CX amplifier is pow- ered off with the rear panel power switch, or when the trigger switch is set to ON or DELAY (see page 2-7 for more detail).

When the unit is on, pressing the standby button activates standby mode and deactivates the CX amplifier. When the unit is in standby, pressing the standby button deactivates standby mode and activates the CX amplifier. The red standby button LED will flash for approximately seven seconds. Then, the blue

2

channel status LEDs will light. If the red standby button LED flashes rapidly and the blue channel status LEDs do not light, the incoming AC voltage is too low or the temperature of the transformer is too high. Refer to Section 3 for troubleshooting information.

Note:

Power is still supplied to the CX amplifier when standby mode is activated.

2-2

Image 10
Contents LX CX Important Safety Instructions Documentation Conventions Introduction ES Desempaquetando E Inspección US Unpacking and InspectionDE Auspackend UND Inspektion FR Déballer ET InspectiónGetting Started About the CX Power Amplifiers Getting StartedInstallation Considerations HighlightsBasic Operation Front Panel Overview Basic OperationStandby Button Channel Status LEDs Color StatusRear Panel Overview Input 1 to 7 CX-7 or 1 to 5 CX-5 Power SwitchAC Input Connector Output 1 to 7 CX-7 or 1 to 5 CX-5Rear Panel Overview Ground Lift Switches UNBAL/BAL SwitchTrigger Input Switch Current Protection Protection ModesThermal Protection DC ProtectionTroubleshooting & Maintenance Troubleshooting & Maintenance TroubleshootingMaintenance Appendix Appendix Appendix Declaration of ConformityIndex Limited Warranty United States