Ryobi 700r Installing the Cutting Attachment Shield, Shaft Housing Cutting Attachment Shield

Page 10

ASSEMBLY INSTRUCTIONS

INSTALLING THE CUTTING

ATTACHMENT SHIELD

Use the following instructions if the cutting attachment shield on your unit is not installed.

WARNING: Never operate the trimmer without the cutting attachment shield in place to prevent serious personal injury.

1.Place the cutting attachment shield onto the shaft housing above the clamp assembly, so that the shield is in front of the cutting attachment (Fig. 4).

Shaft Housing

Cutting Attachment Shield

Cutting Attachment

Fig. 4

2.Push the cutting attachment shield down to the top of the cutting attachment assembly. Rotate the cutting attachment shield so that it points to the engine, and the holes in the cutting attachment shield line up with the holes in the top of the cutting attachment assembly (Fig. 5).

3.Install the four (4) screws with a small Phillips screwdriver (Fig. 5).

Engine

Screw

Cutting Attachment Shield

Cutting Attachment

Fig. 5

Image 10

Contents OPERATOR’S Manual Table of Contents IntroductionCalifornia Emission Regulations Spark ArrestorSymbol Meaning Rules for Safe OperationWhile Operating For Service INFORMATION, Call Safety and International SymbolsSymbol Meaning Safety Alert Symbol Keep Bystanders Away Primer BulbChoke Control HOT Surface WarningSharp Blade Do not USE Blades Indicates OIL Full Choke position Partial Choke positionFuel Cap Know Your UnitApplication On/Off Stop ControlInstalling and Adjusting the D-HANDLE Assembly InstructionsGrip Wing Nut Bolt Washer Shaft Housing Cutting Attachment Shield Installing the Cutting Attachment ShieldEngine Screw Cutting Attachment Shield OIL and Fuel Information Using Blended FuelsUsing Fuel Additives OIL and Fuel Mixing InstructionsChoke Lever Primer Bulb STARTING/STOPPING InstructionsPartial Choke Position B Full Choke Run Position a Starter Rope Throttle ControlHolding the Trimmer Adjusting Trimming Line Length Operating InstructionsFrequency Maintenance Required Refer to Maintenance and Repair InstructionsMaintenance Schedule Tips for Best Trimming ResultsLine Installation Winding the Existing Inner ReelMaintenance and Repair Instructions Removing the Air Filter/Muffler Cover Installing a Prewound ReelAIR Filter Maintenance Choke Lever Partial Choke Position B ScrewsReinstalling the Air filter/Muffler Cover Cleaning the Air FilterAir Filter Adjust Idle Speed Screw Carburetor AdjustmentClean Air Filter Check Fuel Mixture110-120 in.lb .3-13.5 Nm ACCESSORIES/REPLACEMENT PartsReplacing the Spark Plug 020Storage Cleaning and StorageCleaning Long Term StorageTroubleshooting Problem Cause ActionEngine SpecificationsDrive Shaft & String Head Page Owners Warranty Responsibilities Ryobi Outdoor Products Ryobi Canada INC