Echo GT-225 specifications Long Term Storage Over 30 Days

Page 26

STORAGE

GT-225

 

 

STORAGE

During operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear of flammable debris during transportation or when storing, otherwise serious property damage or personal injury may result.

Long Term Storage (Over 30 Days)

Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage maintenance which includes the following:

1. Store unit in a dry, dust free place, out of the reach of children.

Do not store in enclosure where fuel fumes may accumulate or reach an open flame or spark.

2.Place the stop switch in the “OFF” position.

3.Remove accumulation of grease, oil, dirt and debris from exterior of unit.

4.Perform all periodic lubrication and services that are required.

5.Tighten all the screws and nuts.

6.Drain fuel tank completely. Press purge bulb 6 -7 times to remove remaining fuel from carburetor then drain the tank again. Close choke, start and run the engine until it stops due to lack of fuel.

7.

a.Allow engine to cool then remove the spark plug and pour 7 cc (1/4 oz.) of fresh, clean, two-stroke engine oil into the cylinder through the spark plug hole.

b.Pull the recoil starter handle 2-3 times to distribute the oil inside the engine.

c.Observe the piston location through the spark plug hole. Pull the recoil handle slowly until the piston reaches the top of its travel and leave it there.

8.Install the spark plug (do not connect ignition cable).

26

X7722271207

© 03/2013 ECHO Inc.

Image 26
Contents Operator’s Manual Table of Contents Introduction Servicing InformationManual Safety Symbols and Important Information SafetyAdditional or Replacement Manuals Physical Condition International SymbolsPersonal Condition and Safety Equipment Eye ProtectionProper Clothing Breathing ProtectionHearing Protection Hot Humid WeatherClear the Work Area Repetitive Stress InjuriesRead the Manuals Keep a Firm GripEPA 2010 and Later and/or C.A.R.B. Tier Emission Control Exhaust & EvaporativeEquipment Avoid Hot SurfacesEmission Control Exhaust & Evaporative Product Emission Durability Emission Compliance PeriodDescription Description Contents Nylon Line Head Installation AssemblyPlastic Shield Installaion Nylon Line Installation Front Loop HandleFuel Requirements OperationFuel Handling FuelAfter use Starting Cold Engine Purge BulbStarting Warm Engine Stopping EngineSkill Levels MaintenanceMaintenance Intervals Air Filter Fuel FilterSpark Plug Cooling SystemExhaust System Spark Arrestor ScreenEngine Break-In Carburetor AdjustmentExhaust Port Cleaning High Altitude OperationLubrication Troubleshooting Engine Problem Troubleshooting ChartStorage Long Term Storage Over 30 DaysSpecifications ModelWarranty Statements OWNER’S ResponsibilityWarranty Statements GT-225 GT-225 ECHO, Incorporated