Craftsman 358.7951 Before Starting Engine, ON/STOP Switch, Primer Bulb, Choke, Fueling Engine

Page 5

KNOWYOURTRIMMER

READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the loca- tion of the various controls and adjustments. Save this manual fur future refer- ence.

J C"1L1J-.--

 

 

,_i_-I,_Assist- Handle

 

 

 

j

Shield

Muffler

\

Throttle

 

\

 

OIl/STOP

Trigger

_x X

\

 

StarterSW'ch/_._

_

_--_-

Spark Plug

 

 

 

 

Choke Lever

 

 

 

 

 

_e/'Mi_ ulb

 

 

_

 

 

Fill Cap

_Trirnmer

 

 

 

 

 

Head

ON/STOP SWITCH

The STOP switch is used to stop engine. Press and hold switch to stop engine.

PRIMER BULB

The PRIMER BULB removes air from the carburetor and fuel lines and fills them with fuel. This allows you to start the engine with fewer pulls on the starter rope. Activate the primer bulb by pressing it and allowing it to return to its odginal form.

CHOKE

The CHOKE helps to supply fuel to the engine to aid in cold staring. Activats the choke by moving the choke lever to the FULL CHOKE position. After the en- gine attempts to start, move the choke lever to the HALF CHOKE position. Once engine has started, move the choke le- ver to the OFF CHOKE position.

BEFORE STARTING ENGINE

A

WARNING: Be sure to read the fuel information in the safety rules before you begin. If you do not understand the safety rules, do not

attempt to fuel your unit. Call 1-800-235-5878.

FUELING ENGINE

This engine is certified to operate on unleaded gasoline. Before operation, gasoline must be mixed with a good quality 2-cycleair-cooled engine oil. We recommend Craftsman brand oil.

Mix gasoline and oil at a ratio of 40:1 (A 40:1 ratio is obtained by mixing 3.2 ounces of oil with 1 gallon of unleaded gasoline). DO NOT USE automotive oil or boat oil. These oils will cause

engine damage. When mixing fuel, follow instructions printed on container.

Once oil is added to gasoline, shake container momentarily to assure that the fuel is thoroughly mixed. Always read and follow the safety rules relating to fuel before fueling your unit.

IMPORTANT

Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract mois- ture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel sys- tem of an engine while in storage.

To avoid engine problems, empty the fuel system before storage for 30 days or longer. Drain the gas tank, start the engine and let it run until the feel lines

5

Image 5
Contents Craftsman Flailing devices. This unit is designed Troubleshooting ChartTrimmer line throws Unit / Maintenance Safety Operator SafetyFuel Safety Transporting and StorageAssembly Carton ContentsBefore Starting Engine ON/STOP SwitchPrimer Bulb ChokeDifficult Starting or Starting a Flooded Engine Starting a Warm EngineTrimming Operating Instructions OperatingpositionCutting Methods Clean Unit & Labels Maintenance ScheduleClean AIR Filter Check for Loose Fasteners and PartsReplace parts Clean the cover and the area aroundReplacing the Line HubIdle Speed CarburetorStore unit and fuel well out of the reach of children External SurfacesTrouble Cause Remedy Troubleshooting ChartInternal Engine Pair or Replacement Sion Control Warranty