HOW to SET UP Your Trimmer, To Unfold Handle

Read these instructions and this manual in its entirety before you attempt to assemble or operate your new trimmer.

IMPORTANT: This tdmmer is shipped WITHOUT OIL OR GASOLINE in the engine. Your new trimmer has been assembled at the factory with the exception of those parts left

•unassembled for shipping purposes. All parts such as nuts, washers, bolts, etc., necessary to complete the assembly have been placed in the parts bag. To ensure safe and proper operation of your trimmer, all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness.

Loose Parts Packed Separately

TO REMOVE TRIMMER FROM CARTON

•Remove loose parts included with trimmer.

•Cut down two end comers of carton and lay end panel down flat.

•Remove all packing materials.

•Roll trimmer out of carton and check carton thoroughly for additional loose parts.

HOW TO SET UP YOUR TRIMMER

TO UNFOLD HANDLE

IMPORTANT: Unfold handle carefully so as not to pinch or damage control cables.

•Loosen handle knobs enough to allow upper handle to be unfolded from the shipping position.

•Raise upper handle section into place on lower handle and tighten handle knob.

•Remove handle padding holding trimmer head control bar to upper handle.

Safety	20 oz.	Trimmer Lines
Goggles	Bottle of oil	(2) Sets
		(0.130 diameter
		x 16.75 inches long)

Handle knob

Lower handle