Rewinding Spool, Cleaning and Storage | Craftsman 900-74522 specification

REWINDING SPOOL
Use .065" diameter ROUND line only. Do
not use heavier gauge line; it will
overload motor and cause overheating.
1. Insert line end about 118" into the
spool hole as shown in Figures 15
and 16.
2. Snugly and evenly wind the line onto	INSERTLINEHERE
the spool in the direction of the arrow
on the spool until the line builds up to
the notches in the spool rim (Figure
17). Do not overfill spool. The spool
holds about 20 feet of line.
3. Proceed to step 5 of =Spool or Line
Replacement".

CLEANING AND STORAGE

Be sure the tool is unplugged.

1.Keep the air intake slots (Figure 18) clean to avoid overheating.

2.Your trimmer line can dry out oyer

time. To keep your line in top condition, store spare pre-wound spools or bulk line in a plastic, sealable bagwith tablespoon of water.

3.Plastic parts may be cleaned by using a mild soap and a damp rag.

4.DO NOT immerse tool in water or squirt it with a hose. DO NOT allow any liquid to get inside it.

5.Do not store the tool on or adjacent to fertilizers or chemicals.

6.DO NOT clean with a pressure washer.

7.The line cutter on the edge of the guard can dull over time. It is recommended you periodically touch-up the sharpness of the blade with a file.

Conversion Button

Air Intake Slots

•Replacement spool, Craftsman Model No. 85680.

•0,065" diamter ROUND nylon monofilament trimmer line.

The above accesspry is available at your local Sears store or Sears service center.

A, WARNING: The use of any accessory

not sold by Sears for use with this tool could be hazardous.

IMPORTANT: To assure product SAFETY AND RELIABILITY, repairs should be performed by a Sears or other

qualified service facility, using only identical replacement parts.