Cutting line
•Take care against injury from line trimming blade (8) during unpacking and assembly and any excess line which may be cut off when the trimmer is first operated.
• The cutting line (9) will continue to run for a short time after releasing the trigger switch. Under no circumstances should you attempt to stop the cutting line, always allow it to stop on its own.
•Never fit metal cutting line.
Clothing
•Always wear safety glasses when using your machine.
•To protect your feet, always wear stout shoes or boots (not bare footed or wearing open sandals).
•Wear long trousers to protect your legs - any debris left on the lawn or cutting path may be picked up and ejected by the cutting line.
•Use ear protection if the sound level seems uncomfortable when using your machine.
Using your machine
• Always use your machine in the manner |
outlined in this manual. Your machine is |
designed to be used in an upright |
position and if it is used in any other way |
an injury may result. |
• Before using your machine, disconnect it |
from the electrical supply and visually |
inspect the rotating parts for damage. |
Also, check that the spool assembly |
is secure. |
• Always check that your lawn or cutting |
path is clear of all sticks, stones, wire |
and other debris. Contact with such |
debris may damage your machine. |
• Keep your machine away from your feet |
360˚
ENGLISH
•Never use your machine with a damaged guard (10) or without the guard fixed in position.
•Be careful when trimming as freshly cut grass is damp and slippery.
Safety of others
•Remember that the operator/user is responsible for accidents or hazards occuring to other people or their property.
•Never allow children or persons who are unfamiliar with this type of machine to use it, nor anyone who has not read this leaflet.
• Do not allow children, animals or other adults near your machine when in use - always keep them well away from the cutting area.
Care of your machine
•Store your machine in a dry place when not in use, out of the reach of children.
•Do not use solvents or cleaning fluids to clean your machine - use a blunt scraper to remove grass and dirt. Always disconnect from the electrical supply and ensure the cutting line (9) is stationary before cleaning.
•Do not operate your machine if any parts are defective.
•Do not attempt to remove any parts other than those mentioned in these instructions.
•Use only Black & Decker recommended replacement parts and accessories.
| and other parts of your body when |
| switching on and during operation. |
• | Do not switch on your machine when it is |
| upside down. |
• | Walk, never run with the unit. |
• Do not use your machine in the rain and do not allow it to get wet.
•Use your machine only in daylight or good artificial light.
•Do not cross gravel paths or roads whilst the cutting line is rotating.
•Do not cut excessively steep slopes. Be sure of your footing and cut across the face of slopes, never up and down.
Electrical safety
Your machine should always be switched off at the mains before disconnecting any plug and socket connector, extension cables, or cordsets.
Mains plug replacement - UK only
Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt contact a Black & Decker service centre or a qualified electrician.
•Disconnect the plug from the supply.
•Cut off the plug and dispose of it safely, a plug with bared copper conductors is dangerous if engaged in a live socket outlet.
7