uBefore use, check the power supply cord and extension cord for signs of damage, ageing and wear. If a cord becomes damaged during use, disconnect the cord from the mains supply immediately. DO NOT TOUCH THE CORD BEFORE DISCONNECTING THE SUPPLY.
uDo not use the appliance if the cords are damaged or worn.
uWear stout shoes or boots to protect your feet.
uWear long trousers to protect your legs.
uBefore using the appliance, check that your cutting path is free from sticks, stones, wire and any other obstacles.
uOnly use the appliance in the upright position, with the cutting line near the ground. Never switch the appliance on in any other position.
uMove slowly when using the appliance. Be aware that freshly cut grass is damp and slippery.
uDo not work on steep slopes. Work across the face of slopes, not up and down.
uNever cross gravel paths or roads while the appliance is running.
uNever touch the cutting line while the appliance is running.
uDo not put the appliance down until the cutting line has come to a complete standstill.
uUse only the appropriate type of cutting line. Never use metal cutting line or fishing line.
uBe careful not to touch the line trimming blade.
uTake care to keep the mains cable away from the cutting line. Always be aware of the position of the cable.
uKeep hands and feet away from the cutting line at all times, especially when switching on the motor.
uBefore using the appliance and after any impact, check for signs of wear or damage and repair as necessary.
uNever operate the appliance with damaged guards or without guards in place.
uTake care against injury from any device fitted for trimming the filament line length. After extending new cutter line always return the machine to its normal operating position before switching on.
uAlways ensure that the ventilation slots are kept clear of debris.
uDo not use the lawn trimmer (edge trimmer), if the cords are damaged or worn.
uKeep extension cords away from cutting elements.
Labels on appliance
+The following warning symbols are found on the appliance:
F
8 | Keep people and animals at least 6 m away from the |
cutting area. | |
R | Do not expose the appliance to rain or high humidity. |
#This appliance is double insulated; therefore no earth wire is required. Always check that the power supply corresponds to the voltage on the rating plate.Electrical safety
uIf the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard.
Features
This appliance includes some or all of the following features.
1.On/off switch
2.Handle
3.Cable restraint
4.Power inlet
5.Secondary handle
6.Tube
7.Storage hooks
8.Adjustment button
9.Guard
10.Line trimming blade
11.Cutting line
12.Spool housing
13.Edge guide
14.Head
Assembly
Warning! Before assembly, make sure that the tool is switched off and unplugged.
Attaching the tube to the head (fig. A)
uAlign the rectangular tab of the tube (6) with the location in the head (14).
uInsert the tube into the head and push until it clicks into place.
Attaching the handle to the tube (fig. B)
uAlign the square tab of the tube (6) with the location in the handle (2).
uInsert the tube into the handle and push until it clicks into place.
Fitting the guard (fig. C)
uRemove the screw (15) from the head.
uPlace the guard onto the tool as shown.
uFirmly press the guard (9) until it snaps into place.
7