Snapper 1695064 Before Operation, Mowing with the Catcher, Required Accessories, After Operation

Page 5

General Operating Instructions

BEFORE OPERATION

Clear the lawn of all sticks, stones, wire and other debris which may be caught or thrown by the mower blades.

Check grass condition. If wet, wait until later in the day. If grass is wet, the grass catcher is likely to become plugged.

For efficient bagging, air circulation under the mower deck, through the chute and into the bag is very important.

For this reason, BEFORE YOU BEGIN MOWING you should make certain the underside of the mower and the underside of the catcher lid are free from grass and debris.

Make sure that there is a snug fit between mower deck, blower housing, tubes, and grass catcher cover.

MOWING WITH THE CATCHER

Always operate with throttle at full speed when mowing.

Grass should be cut often, and not too short. If grass is too long or lush it may be necessary to keep ground speed to a minimum or to cut only half the width of the mower to prevent clogging. If grass is long, operate with mower in high cutting position for first pass, cutting again in a lower position on a second pass.

Do not open the cover with mower engaged.

If a large amount of cut grass is spilling out from under deck, the tube may be plugged or the bags may be full— discontinue mowing, stop the unit, disengage the PTO, shut off the engine and then empty the catcher or clear the tube.

WARNING

ALWAYS shut off the tractor. Disengage the PTO, and allow all moving parts to stop BEFORE disconnecting or clearing tube, or emptying catcher.

Before leaving the operator’s position for any reason, engage the parking brake, disengage the PTO, stop the engine and remove the key.

To reduce fire hazard, keep the engine, rider and mower free of grass, leaves and excess grease. Do not stop or park rider over dry leaves, grass or combustible materials.

CAUTION

Before you begin operating the unit be certain you have read all of the safety and operational information of this instruction sheet, as well as the Operator’s Manual for the tractor and any other attachments.

REQUIRED ACCESSORIES

A front-mounted factory approved weight carrier and 66 lbs. worth of weights are required when using this rear- mounted grass catcher. Never operate on slopes greater than 17.6% (10°).

AFTER OPERATION

CAUTION

Do not leave grass in bagger containers. Empty containers after each use and before storing. Failure to do so may result in spontaneous combustion which could develop into a fire.

Remove any debris from the the screen on the underside of the lid. Note: The lid screen can be partially removed for easier cleaning and should be cleaned regularly.

The blower housing and tube should be removed for cleaning.

Inspect the grass bags for wear or damage. Make sure that there is a snug fit between mower deck, blower housing, tubes, and grass catcher cover.

STORING THE GRASS CATCHER

Clean the grass catcher thoroughly using a mild deter- gent (other products may damage the tube). Remove any debris from the the screen on the underside of the lid.

If paint has been scratched on metal parts, touch up with paint, or apply a thin film of oil to prevent corrosion.

Store in a dry area. Dry thoroughly before storing for a long period of time. Always store away from moisture.

3

Image 5
Contents OPERATOR’S Manual Clean Sweep Twin CatcherPage Table of Contents Attachment Decals Safety Rules InformationSafety Decals Before Operation Required AccessoriesMowing with the Catcher After OperationInstallation Install Discharge Baffle Turbo InstallationInstall Deflector Hinge Assembly Deflector RemovalModels Install DeflectorInstall Anchor Bracket Install Idler Assembly & Belt GuiderInstall Turbo Drive Pulley Install Mounting Bracket Install Belt Cover PlateInstall Turbo Belt Secure Belt Cover Install Turbo BlowerInstall Turbo Drive Belt Counter Balance & Weight Carrier Installation Initial Counter Balance & Weight Carrier InstallationInitial Hitch & Tube Installation Assemble Catcher Bags Assemble Tubes & DeflectorInitial Collector AssemblyInstall Cover and Bags Removing the Grass Catcher Normal Removal InstallationNormal Removal & Installation Removing and Reattaching Grass Catcher Installing the Grass Catcher