Meade TE827W user manual Channel Switch, WALL-MOUNT Recessed Opening, Rain Gauge

Page 6

C.RESET Resets all readings

D.CHANNEL SWITCH

Selects the desired transmission channel from 1 to 3

E. WALL-MOUNT RECESSED OPENING

Attaches the remote sensor to the wall

Note: Install the batteries and select the channel before mounting the sensor.

Battery installation

•Remove the screws from the battery compartment with a small Phillips screwdriver.

•Set the channel 1 through 3. The switch is located in the battery compartment. Channel 1 is typically selected if only one remote sensor is being used.

•Install 2 “AA” size alkaline batteries (not included) matching the polarities shown in the battery compartment.

•Replace the battery compartment door and secure the screws.

•Secure the thermo-hygrometer remote sensor in the desired location.

Mounting

•The remote thermo-hygrometer sensor can be placed on the flat surface or mounted on the wall in vertical position

•Use the wall mount hardware and screws provided when mounting the thermo-hygrometer sensor on the wall

Placement tips:

•The remote thermo-hygrometer sensor should be placed in the area with a free air circulation and sheltered from the direct sunlight and extreme weather conditions.

•Ideally, place the thermo-hygrometer sensor above the natural surfaces (such as a grassy lawn).

•Avoid placing the thermo-hygrometer sensor near sources of heat such as chimneys and heating elements.

•Avoid any areas collecting and radiating a heat from the sun, such as metal, brick or concrete structures, paving, patios and decks.

•The international standard for the valid air temperature measurements is 4 feet (1.25meters) above the ground.

RAIN GAUGE

FEATURES

•Precipitation measurement

•Remote rainfall data transmission to the main unit via 433 MHz signal

•100 feet (30 meters) transmission range without interference

•Built-in installation level

•Non-corrosive protective screen

B

A

C

A. Rain gauge bucket

Holds all rain gauge components

B. Knob

Secures the top on the rain gauge bucket

C. Rain gauge bucket feet

Allows securing the rain gauge on its place

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents TE827W Table of Contents Introduction Standard Package Contents PictureBattery Compartment InstallationLED Indicator Before YOU BeginChannel Switch WALL-MOUNT Recessed OpeningRain Gauge Funnel-shaped top with battery compartment Wind Vane Battery CoverAnemometer Wind Sensor Wind CupsTime PowerAligning WeatherOperation Buttons and ControlsRequires four 4 AA size batteries Navigating Through the ModesPressure and Weather Forecast Window Displays Clock and Alarms Window Displays Temperature and Humidity WindowRain Window Using Different Weather Modes Customizing Your Weather StationChanging the Sea Level Pressure and Altitude Unit Viewing the Pressure, Temperature and Humidity Bar ChartsViewing the Moon Phase History and Weather Forecast Viewing the Sea Level Pressure HistoryClock and Alarm Mode Disabling or Enabling Snooze function Programming Time AlarmsTo disable alarms Atomic Time ReceptionTemperature and Humidity Mode Rain Mode Wind ModeMaintenance TroubleshootingPrecautions Appendix City Codes DST Daylight Savings Time definitions SA = Australian DST Temperature remote Specifications Radio Frequency 433 MHzTemperature Indoor Barometric PressureFCC Statement Weight without batteriesBattery Safety Instructions Declaration of ConformityStandard Warranty Information
Top Page Image Contents