Snapper R195517B important safety instructions Operation, Maintenance and Storage

Page 3

IMPORTANT SAFETY INSTRUCTIONS

OPERATION

1.DO NOT put hands or feet near or under rotating parts. Keep clear of discharge area while engine is running.

2.STOP engine when crossing gravel drives, walks, or roads, and under any conditions where thrown objects might be a hazard.

3.Mow only in daylight or good artificial light.

4.DO NOT operate mower while under the influence of alcohol or drugs.

5.After striking a foreign object or if mower vibrates abnormally, STOP the engine, disconnect and secure spark plug wire. Inspect the mower for any damage and repair the damage.

6.DO NOT mow near drop offs, ditches or embankments. Operator could lose footing or balance.

7.STAY ALERT for holes and other hidden hazards. Tall grass can hide obstacles. Keep away from ditches, washouts, culverts, fences and protruding objects.

8.DO NOT mow on wet grass. Always be sure of your footing. Keep a firm hold on the handle and walk, never run. Slipping could cause injury.

9.DO NOT leave the machine with the engine running. STOP BLADE and STOP ENGINE before leaving the operators position for any reason.

10.Before cleaning, repairing or inspecting make certain engine, blade and all moving parts have STOPPED. Disconnect and secure spark plug wire away from plug to prevent accidental starting.

11.STOP engine and wait until the blade comes to complete STOP before removing grass bag and/or clearing grass.

12.DO NOT operate mower without the entire grass catcher or guards in place. DO NOT point discharge at people, passing cars, windows or doors.

13.Slow down before turning.

14.Watch out for traffic when near or crossing roadways.

15.DO NOT operate engine in enclosed areas. Engine exhaust gases contain carbon monoxide, a deadly poison.

3

MAINTENANCE AND STORAGE

1.DO NOT store mower or fuel container inside where fumes may reach an open flame, spark or pilot light such as in a water heater, furnace, clothes dryer or other gas appliance. Allow engine to cool before storing machine in an enclosure. Store fuel container out of reach of children in a well ventilated, unoccupied building.

2.Keep mower and engine free of grass, leaves or excess grease to reduce fire hazard and engine overheating.

3.When draining fuel tank, drain fuel into an approved container outdoors and away from open flame.

4.Keep all bolts, especially blade bolts, nuts and screws properly tight. Check that all cotter pins are in proper position.

5.Always provide adequate ventilation when running engine. Engine exhaust gases contain carbon monoxide, a deadly poison.

6.Service engine and make adjustments only when engine is stopped. Removed spark plug wire from spark plug and secure wire away from spark plug to prevent accidental starting.

7.DO NOT change engine governor speed settings or overspeed engine.

8.Check grass bag assembly frequently for wear or deterioration to avoid thrown objects and exposure to moving parts. Replace with new bag if loose seams or tears are evident. Replace slider or bag adapter if broken or cracked.

9.Mower blades are sharp and can cut. Wrap the blades or wear heavy leather gloves and use CAUTION when handling them.

10.DO NOT test for spark by grounding spark plug next to spark plug hole; spark plug could ignite gas exiting engine.

11.Have machine serviced by an authorized SNAPPER dealer at least once a year and have the dealer install any new safety devices.

12.Use only genuine SNAPPER replacement parts to assure that original standards are maintained.

Image 3
Contents Steel Deck Walk Mowers Series Protection for Children Slope OperationPreparation Operation Maintenance and StorageTable of Contents Nomenclature FamiliarizationPrimer Bulb IntroductionOperating Instructions PRE-START Check ListStarting & Operation 2.2.1. Engine & Blade Stopping Handle Height AdjustmentCutting Height Adjustment Recycling Cover REMOVAL/INSTALLATIONRecycling Operation Discharge Deflector Installation Maintenance Service After First 5 Hours 3.2.1. Change Engine OILCheck Mower Blade Storage Procedure Service AnnuallyAdjustments & Repair Mower Blade Replacement 4.1.1. Standard Blade Wear LimitBlade Sharpening Problem Probable Cause Corrective Action TroubleshootingService Performed Each MAINTENANCE/REPLACEMENT PartsUSE HRS Season Disclaimer of Warranty Year Limited WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Snapper Product Registration Form Page Page Page Steel Deck Walk Behind Mowers Series