Snapper EMRP216015B Operating Instructions, 2.5CUTTING HEIGHT ADJUSTMENT, Recycling Operation

Section 2 - OPERATING INSTRUCTIONS

WARNING

DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.

2.5CUTTING HEIGHT ADJUSTMENT

1. Pull the height adjusting latch outward and move to desired cutting height. See Figure 2.7.

IMPORTANT: Move rear height adjustment latch for rear wheel adjustment to correspond with raising or lowering the front wheels to maintain the level of the deck.

	REMOVE HAIR PIN
SWIVEL	AND CLEVIS PIN
WHEEL
MODEL
	SHOWN IN
	LOWEST CUTTING
	HEIGHT

		HIGHEST CUTTING
		HEIGHT
FIXED	1 LOWEST	LATCH
	CUTTING
WHEEL
	HEIGHT
MODEL
	1
	2
	3
	4	6 HIGHEST
	5
	6	CUTTING
		HEIGHT

FIGURE 2.7

2.Set all wheels at the same cutting height. The highest cutting position is Notch 6. The lowest cutting position is Notch 1. See Figure 2.8.

LATCH	6
	5
POSITIONS
	4
	3
1	2

2.6 RECYCLING OPERATION

NOTE: For best recycling results, cut up to a maximum of 1/3 of grass blade length and recycle ONLY when grass is dry.

1.Set all wheels in the highest cutting position (Notch 6).

2.Move engine speed control to “FAST” (Rabbit) position.

3.Move ground speed control to slowest speed setting.

4.Proceed mowing slowly. If grass is very dense, lower each rear wheel latch one notch lower than the front wheel latches to improve recycling performance.

WARNING

DO NOT operate without entire Grass Catcher or guard in place. Grass Catcher components are subject to deterioration during normal use. Inspect frequently and replace worn or damaged components immediately.

2.7INSTALLATION of GRASS CATCHER

Install grass catcher by sliding connector over flange of adapter. Attach grass bag hooks over middle handle cross bar. See Figure 2.9.

FIGURE 2.9

FIGURE 2.8

8