Snapper 447575 manual 15A

SECTION 1 – ASSEMBLY INSTRUCTIONS

HINGE NUT

SPRING

D.Install one of the previously removed bolts into the hole in the center of the discharge opening and through the hole in the adapter. Secure the adapter to the deck with a flat washer and wing nut. See Figure 1.16.

HINGE PIN

FIGURE 1.14

C.Hold the adapter in front of the deck. Align the adapter lugs with the lug retainers in the hinge. Push or lightly tap front of adapter towards the rear until tight against deck. See Figure 1.15.

LUG RETAINERS

ADAPTER

LUGS

	DEFLECTOR
ADAPTER	REMOVED

FIGURE 1.15A

FLAT WASHER &

WING NUT

FIGURE 1.16

E.Attach tube latch to deck adapter. Insert one 1/4-20 x 3/4” Carriage bolt from inside through lower hole in adapter. Place Tube Latch over bolt, followed by 1/4” Internal Tooth lock washer and secure with 1/4-20 hex nut. Align Tube Latch as shown and tighten securely. See Figure 1.17.

TUBE

LATCH

FIGURE 1.17

DEFLECTOR

FIGURE 1.15B

8