Blade Control
Spring
1/4” To 3/8” Extended
FIGURE 3
STEP 9: Check adjustment of wheel drive control spring. With the wheel drive control lever in the "OFF/Released” position measure the length of the wheel drive control spring. Move the wheel drive control lever to the "ON" position and measure spring length. The spring should extend 1/2" to 3/4" from its original length.
WARNING
Engine must be OFF for this adjustment.
If adjustment is needed, unhook wheel drive control spring from cable and rotate spring until proper spring extension is achieved. See Figure 4. Set cutting height as desired.
Wheel Drive
Control
Cable
There should be some slack in cable.
NOTE: Gap between cable eyelet and spring hook.
FIGURE 4
STEP 10: Fill engine to full mark on dipstick. See Engine Manual for proper oil specifications.
STEP 11:
2