Snapper 216015, 216515BV important safety instructions Do not Sharpen Beyond Original Cutting Edge

Page 11

Section 4 - REPAIR & ADJUSTMENTS

WARNING

DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. Wear heavy leather gloves when handling or working around cutting blades. Blades are extremely sharp and can cause severe injury.

4.Sharpen blade on a grinding wheel at an angle of

22to 28 degrees. DO NOT sharpen blade beyond original cutting edge. See Figure 4.4.

DO NOT SHARPEN

BEYOND ORIGINAL

CUTTING EDGE

22-28º

BLADE TIP

END VIEW OF

BLADE ASSEMBLY

ORIGINAL CUTTING EDGE

FIGURE 4.4

5.Check blade for balance. If necessary, correct balance by grinding heavy end of blade.

6.Reinstall blade. See Figure 4.3. Check torque of blade retaining cap screw. Recommended torque should be 30 to 40 ft. lbs.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Steel Deck Walk Mowers Series Important Safety Instructions Operation Table of Contents Nomenclature FamiliarizationIntroduction Starting & Operation 2.2.1. Engine & Blade Operating InstructionsPRE-START Check List Stopping Cutting Height AdjustmentHandle Height Adjustment Attach BAG Hooks Over Middle Handle Cross BAR Storage Procedure MaintenanceService After First 5 Hours 3.2.1. Change Engine OIL Service Annually1A. Ninja Blade Wear Limit Repair & AdjustmentsMower Blade Replacement 4.1.1. Standard Blade Wear Limit Blade SharpeningDo not Sharpen Beyond Original Cutting Edge Problem Probable Cause Corrective Action TroubleshootingUSE HRS Season Service Performed EachMAINTENANCE/REPLACEMENT Parts Disclaimer of Warranty Year Limited WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Page Steel Deck Walk Behind Mowers Series
Top Page Image Contents