IMPORTANT SAFETY INSTRUCTIONS
TOWING
1.Tow only with a machine that has a hitch designed for towing. DO NOT attach towed equipment except at the hitch point.
2.Follow the manufacturer’s recommendation for weight limits for towed equipment and towing on slopes.
3.DO NOT allow children or others on towed equipment.
4.On slopes, the weight of the towed equipment may cause loss of traction and loss of control.
5.Travel slowly and allow extra distance to stop.
MAINTENANCE
(Continued From Previous Column)
16.Use only genuine SNAPPER replacement parts to assure that original standards are maintained.
MAINTENANCE
1.DO NOT store machine or fuel container inside where fumes may reach an open flame, spark or pilot light such as in a water heater, furnace, clothes dryer or other gas appliance. Allow engine to cool before storing machine in an enclosure. Store fuel container out of the reach of children in a well ventilated, unoccupied building.
2.Keep engine free of grass, leaves or excess grease to reduce fire hazard and engine overheating.
3.When draining fuel tank, drain fuel into an approved container outdoors and away from open flame.
4.Check brakes frequently; adjust, repair or replace as needed.
5.Keep all bolts, nuts and screws properly tight. Check that all cotter pins are in proper position.
6.Always provide adequate ventilation when running engine. Exhaust gases contain carbon monoxide, an odorless and deadly poison.
7.Disconnect negative (black) cable from battery before performing maintenance or service. Cranking engine could cause injury.
8.DO NOT work under machine without safety blocks.
9.Service engine and make adjustments only when engine is stopped. Remove spark plug wire(s) from spark plug(s) and secure wire(s) away from spark plug(s).
10.DO NOT change engine governor speed settings or overspeed engine.
11.Lubricate machine at intervals specified in manual to prevent controls from binding.
12.Mower blades are sharp and can cut. Wrap the blades or wear heavy leather gloves and use CAUTION when handling them.
13.DO NOT test for spark by grounding spark plug next to spark plug hole; spark plug could ignite gas exiting engine.
14.Have machine serviced by an authorized SNAPPER dealer at least once a year and have the dealer install any new safety devices.
15.Maintain or replace safety and instruction labels as necessary.
4