250 Z & Javelin Series
Quick Setup List -
Page | Setup Procedure | Steps to Perform |
6 | Uncrating | ❏ Remove crate & banding. |
|
| ❏ Place transmissions in ROLL RELEASE position & roll off |
|
| skid. |
|
|
|
7 | Battery Activation & | ❏ Charge the battery (Note: proceed with other setup steps |
| Installation | while battery is charging). |
|
| ❏ Install & secure battery. |
|
|
|
8 | Check Fluid Levels | ❏ Fill & check Engine oil level. |
|
| ❏ Reduce & check tire pressures |
|
| (Front tires 25 psi, rear tires 15 psi). |
|
|
|
9 | Mower Assembly | ❏ Torque mower blade hardware. |
|
|
|
9 | Lubrication | ❏ Lubricate all grease & oil points. |
|
|
|
10 | SAFETY CHECKS | ❏ Check for LOOSE HARDWARE. |
|
| ❏ Check all OPERATOR CONTROLS. |
|
| ❏ Perform MOWER BLADE STOPPING CHECK. |
|
| (Blade must stop within 5 seconds!) |
|
| ❏ Perform SAFETY INTERLOCK SYSTEM CHECK. |
|
|
|
10 | Burnish Electric Clutch | ❏ Burnish electric clutch (run for 15 seconds, repeat 10 times). |
|
| ❏ Repeat MOWER BLADE STOPPING CHECK. |
(Blade must stop within 5 seconds!)
10/2006 | 5 | TP |