Snapper HWPS26700BV important safety instructions Driven Disc Adjustment

Page 14

Section 4 - REPAIR & ADJUSTMENTS

WARNING

DO NOT attempt any adjustments, maintenance or service with the engine or blade running. STOP blade. STOP engine. Remove spark plug wire from spark plug and secure wire away from spark plug. Engine and components can be extremely hot. Avoid burns by allowing engine and components sufficient time to cool.

4.3.3. DRIVEN DISC ADJUSTMENT

The driven disc position is set at the factory and should not require adjustment. The proper adjustment is displayed in Figure 4.5. If adjustment is required proceed as follows.

1.Loosen jam nut from ball joint on transfer rod.

THRUST PLATE AND DECK BRACKET

SHOULD TOUCH IN 1st GEAR.

TRANSFER

ROD

DRIVE

DISC

LOOSEN

JAM NUT

OUTER

EDGE

(SHOWN IN 6th)

FIGURE 4.5

2.Remove transfer rod retaining clip. See Figure

TRANSFER ROD

GROUND SPEED

CONTROL ROD

RETAINING

CLIP

FIGURE 4.6

3.Remove driven disc spring.

4.Place ground speed control in the 1st speed position.

5.The thrust plate and deck bracket should touch in 1st gear.

6.Adjust transfer rod by rotating clockwise or counter-clockwise as needed until it will just slide into hole on ground speed control rod.

7.Attach transfer rod to speed control rod and install retaining clip.

8.Tighten jam nut on transfer rod ball joint.

9.Attach spring to thrust plate.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Steel Deck High Wheel Walk Mower Series Important Safety Instructions From Previous Do not refuel the machine indoorsTable of Contents Introduction NomenclatureOn Next PRE-START Check ListStarting & Operation 2.2.1. to Start Engine Propelling Mower Wheel Drive Starting & OperationBlade Stopping Wheel DriveCutting Height Adjustment Front Wheels Handle Height AdjustmentCutting Height Adjustment Rear Wheels Recycling Operation Optional Grease DECK/BLADE Spindle Service After First 5 Hours Change Engine OILService Engine Grease Front Caster Bushings Check Blade BrakeCheck Mower Blade Service AnnuallyStorage Procedure Check Wheel Drive ControlMower Blade Replacement 4.1.1. Standard Blade Wear Limit Blade SharpeningDrive Spring Repair/Replacement Driven Disc ServiceCleaning Drive Disc & Driven Disc Driven Disc Adjustment Replacing Bearing In Driven Disc Wheel Drive Belt Service Engine to Drive Disc Belt ReplacementEngine to Deck Belt Replacement Blade Brake Adjustment Troubleshooting Problem Probable Cause Corrective ActionService Performed Each USE HRS SeasonYear Limited Warranty Disclaimer of WarrantySnapper Product Registration Form Primary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Service Notes Service Notes Steel Deck Walk Mowers Series
Top Page Image Contents