Snapper RP2167519BDV important safety instructions Installation of Grass BAG Door Type Bag

Page 10

Section 2 - OPERATING INSTRUCTIONS

WARNING

DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.

2.8INSTALLATION OF GRASS BAG ADAPTER (Optional Accessory on Some Models)

STEP 1: Remove recycling cover. Refer to Section “Recycling Operation”.

STEP 2: Install grass bag adapter to the deck in place of

recycling cover, making sure that: 1) hole on outside front of adapter fits onto stud in front of discharge opening where front of recycling cover was originally installed, 2) slot on top of adapter slips under restraining nut on top of deck (under right front corner of engine), and 3) slot on bottom rear of adapter slips onto stud behind rear of discharge opening, where rear of recycling cover was originally secured. See Figure 2.10. Install internal/external tooth lock washers and knob nuts on studs and tighten securely.

STEP 3: Route recoil rope around outside of rope guide

pulley. See Figure 2.10. (NOTE: Recoil rope may need to be slackened. Refer to “Handle Assembly”.)

ROUTE RECOIL ROPE

AROUND PULLEY

SECURE

ADAPTER

TO DECK

FIGURE 2.10

2.9INSTALLATION OF GRASS BAG (Door Type Bag)

STEP 1: Install grass bag adapter. Refer to Section “Installation of Grass Bag Adapter”.

STEP 2: Install grass bag by sliding connector over adapter flange. See Figure 2.11.

STEP 3: Attach grass bag hooks over middle handle cross bar. See Figure 2.11.

HOOK TO MIDDLE

HANDLE CROSS BAR

SLIDE

CONNECTOR

OVER FLANGE

FIGURE 2.11

WARNING

DO NOT operate without entire Grass Catcher or guard in place. Grass Catcher components are subject to deterioration during normal use. Inspect frequently and replace worn or damaged components immediately.

WARNING

Grass Catcher bags used on SNAPPER products are made of woven fabric, and are subject to deterioration and wear during normal usage. Check condition of bag before each use. Immediately replace worn or damaged catcher bags with only bags recommended by SNAPPER. The grass catcher is optional equipment on some models.

10

Image 10
Contents Engine Option Model Designation Cutting Width Engine PowerModel Number Explanation Engine DesignationImportant Safety Instructions From Previous ColumnFrom Previous Do not refuel the machine indoorsEngine Power Rating Information Table of Contents Introduction Briggs Engine Speed ControlNomenclature PRE-START Check List Starting & Operation Engine & BladeStarting & Operation 2.2.3. Propelling Mower Cutting Height AdjustmentHandle Height Adjustment StoppingRecycling Operation Installation of Side Discharge DeflectorTo Remove Recycling Cover Installation of Grass BAG Door Type Bag Dispose of drain oil properly Service After First 5 Hours 3.2.1. Change Engine OILImportant Drain fuel tank before tipping mower Check Mower Blade Service AnnuallyStorage Procedure Check Engine Drive BeltBlade Sharpening Mower Blade Replacement Standard Blade Wear Limit1.A. Ninja Blade Wear Limit Wheel Drive Control Adjustment Drive Spring Repair/Replacement Driven and Drive Disc ServiceCleaning Drive Disc & Driven Disc Driven Disc AdjustmentOn Next Replacing Rubber Driven Disc Repair & Adjustments Engine Drive Belt Replacement Stretch Type Belts Belt ServiceOn Next Reinstall blade hub and cutter blade Pulley PositionProblem Probable Cause Corrective Action100 Service Performed EachMAINTENANCE/REPLACEMENT Parts USE HRS SeasonYear Limited Warranty Disclaimer of WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Snapper Product Registration Form Steel Deck Recycling Walk Mowers Series