Section 2 - OPERATING INSTRUCTIONS
WARNING
DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.
2.6RECYCLING OPERATION (Optional Accessory)
NOTE: For best recycling results, cut up to a maximum of 1/3 of grass blade length and recycle ONLY when grass is dry.
1.Set all wheels in the highest cutting position (Notch 6).
2.Move engine speed control to “FAST” (Rabbit) position.
3.Move ground speed control to slowest speed setting.
4.Proceed mowing slowly. If grass is very dense, lower each rear wheel latch one notch lower than the front wheel latches to improve recycling performance.
2.7INSTALLATION of GRASS CATCHER
Install grass catcher by sliding connector over flange of adapter. See Figure 2.8. Attach grass bag hooks over middle handle cross bar. See Figure 2.9.
POSITION BAG
BETWEEN HANDLES
CONNECTOR
BAG
ADAPTER
FIGURE 2.8
ATTACH BAG HOOKS
OVER MIDDLE HANDLE
CROSS BAR
SLIDE CONNECTOR DOWN OVER BAG ADAPTER FLANGE
MIDDLE
HANDLE
CROSS
BAR
FIGURE 2.9
WARNING
DO NOT operate without entire Grass Catcher or guard in place. Grass Catcher components are subject to deterioration during normal use. Inspect frequently and replace worn or damaged components immediately.
8