Square END CAP | Snapper Simplicity RZT Riding Mowers specs

b. Install the catcher support onto the unit, securing with the hardware noted in Figure 9. Tighten all hardware securely. NOTE: Be sure to reinstall any components that may have been removed when removing the hardware in Step 7a.

2” BOLT (2)

SQUARE

END CAP (2)

SECURE WITH SUPPLIED 5/16 x 3/4” HEX WASHER HEAD BOLT &

FLANGE NUT

SECURE WITH SUPPLIED 5/16 x 3/4” HEX WASHER HEAD BOLT

2-1/4” BOLT (2)

ROUND

END

CAP (8)

LOCK

NUT (4)

BAGGER

CHANNEL

FIGURE 9

SECURE WITH

REMOVED

HARDWARE

FIGURE 11

STEP 10: Install the cover handle onto the screen support bar, behind the front of the cover assembly, securing with two pan head screws and lock nuts. See Figure 12.

STEP 8: Insert the bagger channel into the grass catcher support, and secure with two 1/2 x 4-3/16” clevis pins, washers, and hair pins. See Figure 10.

INSERT CHANNEL

INTO CATCHER

SUPPORT

WASHER &

HAIR PIN (2)

CLEVIS PIN (2)

CATCHER

SUPPORT

(SHOWN

DETACHED

FROM UNIT)

FIGURE 10

STEP 9: Install the catcher frame into the top of the bagger channel, securing with two 5/16 x 2-1/4” hex bolts in the inner two holes, and two 5/16 x 2” hex bolts in the outer two holes. See Figure 11. Secure the bolts with four hex center lock nuts, tightening securely. Also, Insert one square end cap into each end of the square tube, and one round end cap into each end of the four round tubes. See Figure 11.

NOTE: On some units, the cover handle has been pre- assembled onto the cover assembly.

LOCK NUT (2)

COVER

HANDLE

PAN HEAD

SCREW (2)

FIGURE 12

STEP 11: Attach the cover assembly to the bagger channel by aligning the holes in the cover hinge with the top set of holes in the bagger channel. Insert the hinge pin through the holes, and secure with a hair pin. See Figure 13.

COVER

ASSEMBLY

HAIR PIN

		BAGGER
HINGE PIN		CHANNEL

FIGURE 13