Snapper S2265FC, SP2265FC, SPV22675HWFC Safe Handling of Gasoline From Previous, Operation

Page 5

!

Important Operator Safety Instructions (Continued)

!

Safe Handling of Gasoline

(Continued From Previous Page)

6.DO NOT fill fuel containers inside a vehicle or on a truck or trailer bed with a plastic liner. Always place the contain- ers on the ground away from the vehicle before filling.

7.Remove gas-powered equipment from the vehicle or trailer and refuel it on the ground. If this is not possible, then refuel equipment using a portable container, rather than a gasoline dispenser nozzle.

8.DO NOT start gas powered equipment in enclosed vehi- cles or trailers.

9.Keep the nozzle in contact with the rim of the fuel tank or container opening at all times until fueling is complete. DO NOT use a nozzle lock-open device

10.If fuel is spilled on clothing, change clothing immediately.

11.DO NOT overfill a fuel tank. Replace fuel cap and tight- en securely.

Operation

1.DO NOT put hands or feet near or under rotating parts. Keep clear of discharge area while engine is running.

2.STOP engine when crossing gravel drives, walks, or roads, and under any conditions where thrown objects might be a hazard.

3.Mow only in daylight or good artificial light.

4.DO NOT operate mower while under the influence of alcohol or drugs.

5.After striking a foreign object or if mower vibrates abnormally, STOP the engine, disconnect and secure spark plug wire. Inspect the mower for any damage and repair the damage before starting.

6.DO NOT mow near drop offs, ditches or embankments. Operator could lose footing or balance.

7.STAY ALERT for holes and other hidden hazards. Tall grass can hide obstacles. Keep away from ditches, washouts, culverts, fences and protruding objects.

8.DO NOT mow on wet grass. Always be sure of your footing. Keep a firm hold on the handle and walk, never run. Slipping could cause injury.

9.ALWAYS stay behind handle when engine (motor) is running.

10.DO NOT leave the machine with the engine running. STOP BLADE and STOP ENGINE before leaving the opera- tors position for any reason.

11.Before cleaning, repairing or inspecting make certain engine, blade and all moving parts have STOPPED. Disconnect and secure spark plug wire away from plug to prevent accidental starting.

12.STOP engine and wait until the blade comes to com- plete STOP before removing grass bag and/or clearing grass.

Operation

(Continued From Previous Column)

13.DO NOT operate mower without the entire grass catch- er, or guards in place discharge guard, rear guard or other safety devices in place and working. DO NOT point dis- charge at people, passing cars, windows or doors.

14.DO NOT discharge material against a wall or obstruc- tion. Material may ricochet back towards the operator.

15.Slow down before turning.

16.Watch out for traffic when near or crossing roadways.

17.DO NOT operate engine in enclosed areas. Engine

exhaust gases contain carbon monoxide, a deadly poison.

18.Only use accessories approved by the manufacturer. See manufacturer’s instructions for proper operation and installation of accessories.

Maintenance and Storage

1.DO NOT store mower or fuel container inside where fumes may reach an open flame, spark or pilot light such as in a water heater, furnace, clothes dryer or other gas appli- ance. Allow engine to cool before storing machine in an enclosure. Store fuel container out of reach of children in a well ventilated, unoccupied building.

2.Keep mower and engine free of grass, leaves or excess grease to reduce fire hazard and engine overheating.

3.When draining fuel tank, drain fuel into an approved container outdoors and away from open flame.

4.Keep all bolts, especially blade bolts, nuts and screws properly tight. Check that all cotter pins are in proper position.

5.Always provide adequate ventilation when running engine. Engine exhaust gases contain carbon monoxide, a deadly poison.

6.Service engine and make adjustments only when engine is stopped. Removed spark plug wire from spark plug and secure wire away from spark plug to prevent accidental starting.

7.DO NOT change engine governor speed settings or overspeed engine.

8.Check grass bag assembly frequently for wear or deterioration to avoid thrown objects and exposure to moving parts. Replace with new bag if loose seams or tears are evident. Replace slider or bag adapter if broken or cracked.

9.Mower blades are sharp and can cut. Wrap the blades or wear heavy leather gloves and use CAUTION when handling them.

10.DO NOT test for spark by grounding spark plug next to spark plug hole; spark plug could ignite gas exiting engine.

11.Have machine serviced by an authorized SNAPPER dealer at least once a year and have the dealer install any new safety devices.

12.Use only genuine SNAPPER replacement parts to assure that original standards are maintained.

Operator Safety

3

Image 5
Contents Walk Behind Mowers Engine Date of Purchase Retailer Retailers Phone Number EquipmentTable of Contents Slope Operation Protection for ChildrenPreparation Preparation From Previous ColumnSafe Handling of Gasoline From Previous Maintenance and StorageOperation Operation From Previous ColumnHandle PreparationUnpacking Handle Height Adjusting the handle heightAssembling the Grass Bag Installing the frame assemblyEmptying the Grass Bag Mounting the Grass BagAttaching the Side Mounted Discharge Deflector Final Preparation Mulching TipsPreparing the Engine Engine Stop Lever OperationFront Wheel Drive System Self-Propelled Units Only Stopping the EngineRules for Safe and Effective Operation Starting the EngineEngine Maintenance MaintenanceCleaning the Mower Housing Engine TippingRemoving the belt cover Removing the Drive Belt Self-Propelled Units OnlyAdjusting the drive cable Adjusting the Drive Cable Self-Propelled Units OnlyRemoving the Blade Blade ServiceSharpening the Blade Checking the Level of CutSharpening the blade Preparing the Mower for StorageTroubleshooting Year Limited Warranty Slope Guide Page Page Walk Behind Mowers Common Service Parts