Snapper SPV21675, SPV21675E, NSPV21675, NSPV21675E Rear Cover Removal and Installation

Page 17

!

WARNING

!

DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.

Rear Cover Removal and Installation

To Remove the Rear Cover

1.Remove the three fasteners (A, Figure 24) securing the rear apron to the machine.

2.Remove the two fasteners (B) securing the rear cover to the machine.

3.Slide the cover (C) down and out to remove. Set all components aside.

To Install the Rear Cover

1.Reverse steps 1-3 above, making sure the tab (D) on the rear cover is located on the outside of the machine.

D

 

C

 

B

Maintenance

 

 

A

Figure 24: Removing the rear cover

 

15

Image 17
Contents Variable Speed Rear Discharge Walk Behind Mowers Engine Product RegistrationDate of Purchase Retailer Retailers Phone Number Equipment Table of Contents Slope Operation Protection for ChildrenPreparation From Previous ColumnOperation Maintenance and StorageFeatures and Controls Engine and Blade Pre-Start Check ListStarting and Operation Propelling the Mower Handle Height AdjustmentStopping Recycling Operation Cutting Height AdjustmentInstalling the Discharge Deflector Removing the Recycling Plug Installing the Grass BagService Periodic Maintenance IntroductionService After First 5 Hours Wheel Drive Components Storage ProcedureBlade Sharpening Mower Blade ReplacementStandard Blade Wear Limit Wheel drive controls Components removed for clarity Wheel Drive Control AdjustmentEngine Drive Belt Replacement Belt ServiceBattery Service To Remove the Rear Cover Rear Cover Removal and InstallationTo Install the Rear Cover Maintenance/Replacement Parts Service ScheduleProbable Cause Corrective Action TroubleshootingDisclaimer of Warranty Year Limited WarrantyPage Page Page Part Number Common Service Parts