Snapper SPEL150KH, SPE481, SPE361 Handle Height, Transmission Shift Lever Adjustment

Page 21

SECTION 5 - ADJUSTMENTS

5.3 HANDLE HEIGHT

The operator handle can be adjusted for operator comfort as follows:

1.Loosen the upper carriage bolt and nut on both left and right lower handles. See Figure 5.3.

2.Remove lower carriage bolt and nut from both left and right handles.

3.Raise or lower handlebar to desired height. See Figure 5.3.

4.Align handle with one of the adjustment holes in the tank support bracket and insert the carriage bolt. See Figure 5.3.

5.Verify that the handle is still at desired height. Using nuts removed in Step 2, tighten both lower carriage bolts securely.

6.Securely tighten both upper carriage bolts and nuts.

7.The Traction Levers will require adjustment after the handle height has been adjusted. Refer to Section “ADJUSTMENTS – Traction Levers/Rods”.

8.The Transmission Shift Lever linkage will require adjustment after the handle height has been adjusted. Refer to Section “ADJUSTMENTS – Transmission Shift Lever”.

RAISE

LOOSEN

UPPER

CARRIAGE

BOLT

LOWER

REMOVE

LOWER

CARRIAGE

BOLT

FIGURE 5.3

5.4TRANSMISSION SHIFT LEVER ADJUSTMENT

1.Disconnect the hair pin from shift rod that connects to the Transmission Shift lever. See Figure 5.4.

2.Move the Transmission Shift lever to the neutral position. Move the shift lever, located on the transmission, to the neutral position.

3.Rotate the shift rod clockwise or counter clockwise to allow the upper portion of shift rod to be inserted into the Transmission Shift lever without moving the

speed control lever or the transmission shift lever. Reinstall hair pin. See Figure 5.5.

TRANSMISSION

SHIFT

LEVER

DISCONNECT

 

SHIFT ROD

SHIFT

FROM THIS

ROD

POINT

 

FIGURE 5.4

SHIFT

LEVER

SHIFT

ROD

ROTATE

SHIFT

ROD

FIGURE 5.5

21

Image 21
Contents Model Number Explanation PRO Gear Express Walk Behind Mowers MID-SIZE SeriesProtection for Children Important Safety InstructionsSlope Operation PreparationOperation MaintenanceImportant Safety Instructions Table of Contents Familiarization IntroductionNomenclature Safety Messages and Symbols Important Safety and Operating Insructions Keep Children and Others OUT of the Mowing Area Traction Lever Locked Position ControlsBefore Operating Operating InstructionsStopping Machine PRE-START Check ListFrom previous On next Reverse Operation Mowing and Turning on Hillsides Traction Lock OperationTurning Mower Traction Lever PositionAdjusting Blade on Cutter Spindle Adjusting Caster WheelsAdjusting Blade on Cutter Adjusting Fixed Deck AttachmentSide Profile of Unit Symptom Problem Solution TroubleshootingHours Procedure Comments Mower TroubleshootingAdjustments STEERING/BRAKESTraction LEVERS/RODS Handle Height Transmission Shift Lever AdjustmentPower Unit Service Replacement PartsTransmission Parts & Service Transmission Belt REMOVAL/REPLACEMENT Mower Attachment ServiceTraction Belt Removal & Replacement Cutter Deck Belt Removal & InstallationCutting Blade Service Standard Replacement BladesBlade Removal and Sharpening Remove NUT Remove Belt From Spindle Remove Blade Bolt Electrical Disclaimer of Warranty Year Limited WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Page Page PRO Gear Express MID-SIZE Walk Behind Mowers Series