Snapper YZ16335BVE, YZ16385BVE Checking Mower Belt Tension, Service Every 25 Operating Hours

Page 12

Section 3 - MAINTENANCE

WARNING

DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. Stop engine. Stop blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid serious burns, allow all parts to cool before working on machine. Fuel Filler Cap and Vent must be closed securely to prevent fuel spillage.

3.2.3.CHECK MOWER DRIVE BELT 1. Footrest/Floor pan Removal

a. Pull deck lift handle to highest cutting position. See Figure 3.3.

b. Remove the two knobs that secure the rear of the floor pan.

c. Remove two bolts at front bottom edge of foot rest. Lift up on footrest and slide rear of floor pan out from under deck lift mechanism.

MOVE DECK LIFT HANDLE TO HIGH CUT REMOVE TWO KNOBS AT REAR OF FLOOR PAN REMOVE TWO BOLTS FROM BOTTOM OF FOOTREST

FIGURE 3.3

2.Checking Mower Belt Tension

The idler and spring provide proper belt tension and require no adjustment. If belt is frayed, slit, severed or belt strands exposed, replace belt before operating mower.

3.2.4.CHECK TRANSAXLE DRIVE BELTS 1. Checking Transaxle Belt Tension

The transaxle drive belts require no adjustment. If belts are frayed, slit, severed or belt strands exposed, replace belt before operating mower.

3.3SERVICE - EVERY 25 OPERATING HOURS

3.3.1.ENGINE

1. Engine Cooling System

The engine cooling system consists of an engine shroud and engine fins. These should be kept clean and free of debris as needed or cleaned.

2. Engine Oil

Change engine oil. Refer to Section “CHANGE ENGINE OIL”. Refer to engine owner’s manual for oil specifications.

3. Oil Filter

Change engine oil filter. Refer to engine owner’s manual for filter specifications.

4. Air Filter

Refer to engine owner’s manual for service instructions.

5. Air Filter

1.Refer to engine owner’s manual for service instructions. Change air filter. Pull up and rotate the air cleaner latch to remove cleaner cover. See Figure 3.4.

IMPORTANT: When cover is removed, you are viewing the carburetor side of the air filter, which will appear clean. Remove filter and pre-cleaner for inspection.

AIR CLEANER

LATCH

AIR CLEANER

COVER

FIGURE 3.4

(Continued On Next Page)

12

Image 12
Contents Scrambler Model Number ExplanationProtection for Children Protection Against Tipovers PreparationSafe Handling of Gasoline OperationMaintenance Table of Contents Introduction NomenclatureOperating Instructions PRE-START Check ListStarting & Operation Engine Electric Start Mower Blade StoppingEngine Parking BrakeCutting Height Adjustment Engine Must not Start ifEngine should Start if Engine Must Begin to Stop ifService After First 5 Hours Change Engine OILCheck Mower Blade Single Blade DeckService Every 25 Operating Hours Checking Mower Belt TensionEngine Engine Cooling System Engine Oil Oil Filter Air FilterCheck Engine Mower ComponentsUnderside View of 33 Deck Scrambler Lubrication 1. Front Wheel Bearings Front Caster Wheel Pivot ShaftParking Brake Pivot Bushings Service Annually Storage OUT of SeasonNeutral Position Adjustments Engine Adjustments & RepairLower View Front of Mower Is Shown From this Angle Mower Drive Belt Adjustment Belt ReplacementDeck Belt RemovalBlade Brake Adjustment Belt ReplacementsAdjusting Mower Blade From PreviousAdjusting the 33 Deck Blade + 1/16Front or Rear View of Deck Deck ShownFront to Rear Deck Pitch 38 Decks Mower Deck Timing RODWheel Brake Adjustment Mower Blade Replacement 4.4.1. Blade Wear LimitsBlade Sharpening Blade Replacement Chart Mower Blade Replacement 4.4.3. Blade ReplacementBattery Battery Removal Battery ServiceBattery Testing NEW Battery Preparation 1. Remove battery from cartonProblem Probable Cause Trouble Shooting on NextCorrective Action Problem Probable Cause Corrective Action Excessive VibrationService Performed Each MAINTENANCE/REPLACEMENT Parts100 USE HRS SeasonYear Limited Warranty Disclaimer of WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Snapper Product Registration Form Page Page Page Scrambler Hydro Drive Series