Dynacord CL 200 manual Front, Rear, CL Series, Safety Package

Power Amplifiers

FRONT

The dB-calibrated level controls are implemented as ultra-precise detent potentiometers that are recessed in the front panel to protect them from accidental contact. Power, Protect, Signal and Limit LEDs provide a quick overview of the operating status.

REAR

The electronically balanced XLR IN / OUT sockets are provided for direct operation with professional mixing consoles and signal processors. All the models in the CL series are designed for a Constant Gain of 32 dB. The power outputs for Channels A and B are on Speakon connectors. A Ground Lift switch is also provided to separate the chassis ground from the signal ground in order to eliminate ground loop hum.

CL SERIES

CL800 Rated at 2 x 600 watts into 2 ohms and 2 x 400 watts into 4 ohms, the smallest power amplifier in the CL series, which uses class AB technology, weighs in at a mere 13 kg and is the- refore the ideal amp for fairly small full-range cabinets.

CL1200 Delivering a reliable 2 x 900 watts into 2 ohms and 2 x 600 watts into 4 ohms, this is the ideal amplifier for a wide variety of full-range cabinets and MF/HF components in multi- way systems.

CL1600 Rated at 2 z 1100 watts into 2 ohms and 2 x 800 watts into 4 ohms, this amplifier is ideal for use with professional full- range cabinets and also passive TOP/SUB combinations.

CL2000 The flagship of the CL series delivers a hefty 2 x 1400 watts into 2 ohms and 2 x 1000 watts into 4 ohms, whilst weighing a mere 18 kg. Ideal for driving large subwoofer arrays as well as full-range and MID-HIGH components with high power handling.

SAFETY PACKAGE

The complete CL series is equipped with protections against overheating, overloading, short-circuits, DC and HF as well as a Back-EMF protection. With the Soft Start system, the power outputs are switched on via a relay when a safe operational state has been reached and a power-up delay prevents the mains fuses being activated.