Snapper 1723846 Install Mounting Plates Broadmoor / 1600 / 2600 / LT Series, Install Spacers

Page 5

Initial Assembly & Installation

INSTALL MOUNTING PLATES - BROADMOOR / 1600 / 2600 / LT SERIES

Install Plates & Spacers

1.Mount the side brackets (B, Figure 1) to both sides of the frame using the holes shown. Secure with one 3/8-16 x 1 capscrew (C) and 3/8-16 nylock nut (A) per side.

A

B

C

2.Install the rear spacers (C, Figure 2). Secure with two 1/2-13 x 2-1/2 capscrews (E), washers (D), spac- ers (C), and 1/2-13 nylock nuts (A) per side.

Figure 1. Install Side Brackets

A. Nylock Nut, 3/8-16 C. 3/8-16 x 1 B. Side Bracket

A

 

 

C

 

D

D

B

Figure 2. Install Rear Spacers

 

A. Nylock Nuts, 1/2-13

C. Spacers

B. 1/2-13 x 2-1/2 Capscrew

D. 1/2” Washers

INSTALL MOUNTING SPACERS - CONQUEST / 1700 / 2700 / YT & PRESTIGE / 1800 / 2800 / GT SERIES

NOTE: If installing this catcher on a unit equipped with a rear tiller, refer to the “Installation with a Tiller” section for special installation instructions.

Install Spacers

1.Install the rear spacers (C, Figure 3). Secure with two 1/2-13 x 2-1/2 capscrews (E), washers (D), spac- ers (C), and 1/2-13 nylock nuts (A) per side.

A

 

 

C

 

D

D

B

 

Figure 3. Install Rear Spacers

A. Nylock Nuts, 1/2-13 C. Spacers

B. 1/2-13 x 2-1/2 Capscrew D. 1/2” Washers

4

Image 5
Contents OPERATOR’S Manual Turbo Clean Sweep Twin CatcherTable of Contents Attachment Decals Safety Rules InformationSafety Decals Before Operation Required AccessoriesMowing with the Catcher After OperationInstall Spacers Install Mounting Plates Broadmoor / 1600 / 2600 / LT SeriesInstall Plates & Spacers Assemble Supports and Hitch Catcher Assembly ALL ModelsAssemble & Install Tubes Install Cover and BagsRemoval Normal Removal InstallationInstallation Installation with a Tiller Installation with a TillerInitial Setup Installation & RemovalPage Hardware Identification & Torque Specifications