Snapper 7600004 manual Unit assembly

3

unitassembly

RAISE UNIT

HOOK CLAMSHELL

MOUNT ONTO

BUMPER MOUNT

PLATE PINS

SECURE

WITH

HAIR PIN

SLIDE ROD

THROUGH

HOLES

MAKE SURE

BEND IS UP

HOOK

LARGE

HOLE OF

ARM

HERE

BOLT ARM TO

INSIDE OF HANDLE

PUSH HANDLE

DOWN TO

LOCK COVER

STEP 13: Hook bottom of clamshell mount onto pins in bottom of bumper mount plate, then raise clamshell assembly up against bumper mount.

IMPORTANT: Assistance is required when installing clamshell unit.

STEP 14: Slide hitch rod through aligned holes in clamshell mount and bumper mount plate, secur- ing with hair pin.

IMPORTANT: Assistance is required when installing clamshell unit.

STEP 15: Hook the large hole of each actuating arm onto the hook on each side of the rear cover. Then secure the other end of the arm onto the inside of each side of the handle weldment with one 3/8-16 x 2” hex bolt and nyloc nut. Tighten snugly. NOTE: Make sure bend of arm is up.

Push handle down to lock cover.

8