Snapper 3250 Watt Generator
TROUBLESHOOTING
Problem | Cause | Correction | |||
|
|
|
|
| |
| 1. | One of the circuit breakers is | 1. | Reset circuit breaker. | |
|
| open. |
|
| |
Engine is running, but no AC or | 2. | Fault in generator. | 2. | Contact Authorized service facility. | |
3. | Poor connection or defective cord | 3. | Check and repair. | ||
DC output is available. | |||||
| set. |
|
| ||
|
|
|
| ||
| 4. | Connected device is bad. | 4. | Connect another device that is in | |
|
|
|
| good condition. | |
|
|
|
|
| |
Engine runs good at | 1. | Short circuit in a connected load. | 1. | Disconnect shorted electrical load. | |
|
|
|
| ||
"bogs down" when loads are | 2. | Generator is overloaded. | 2. | See "Don't Overload Generator". | |
connected. | 3. | Shorted generator circuit. | 3. | Contact Authorized service facility. | |
| |||||
|
|
| |||
Engine will not start; or starts and | Low oil level. | Fill crankcase to proper level or place | |||
runs rough. |
|
| generator on level surface. | ||
|
|
|
|
| |
| 1. | Out of gasoline. | 1. | Fill fuel tank. | |
Engine shuts down when running. | 2. | Low oil level. | 2. | Fill crankcase to proper level or | |
|
|
|
| place generator on level surface. | |
|
|
| |||
Engine lacks power. | Load is too high. | See "Don't Overload Generator". | |||
|
|
|
|
| |
12