IMPORTANT SAFETY INSTRUCTIONS
SAFE HANDLING OF GASOLINE
(Continued From Previous Page)
3.DO NOT remove fuel cap or add fuel with the engine running. Allow the engine to cool before refueling.
4.DO NOT refuel the machine indoors.
5.DO NOT store the machine or fuel container inside where there is an open flame, spark or pilot light such as on a water heater or other appliances.
6.DO NOT fill fuel containers inside a vehicle or on a truck or trailer bed with a plastic liner. Always place the containers on the ground away from the vehicle before filling.
7.Remove
8.DO NOT start gas powered equipment in enclosed vehicles or trailers.
9.Keep the nozzle in contact with the rim of the fuel tank or container opening at all times until fueling is complete. DO NOT use a nozzle
10.If fuel is spilled on clothing, change clothing immediately.
11.DO NOT overfill a fuel tank. Replace fuel cap and tighten securely.
OPERATION
1.DO NOT put hands or feet near rotating parts. Keep clear of intake and discharge areas while engine is running.
2.STOP engine when crossing gravel drives.
3.Operate machine only in daylight or good artificial light.
4.DO NOT operate machine while under the influence of alcohol or drugs.
5.If machine vibrates abnormally, STOP the engine, disconnect and secure spark plug wire. Inspect the machine for any damage and repair the damage before resuming operation.
6.DO NOT operate machine near drop offs, ditches or embankments. Operator could lose footing or balance.
7.STAY ALERT for holes and other hidden hazards. Keep away from ditches, washouts, culverts, fences and protruding objects.
8.DO NOT operate machine on wet grass. Always be sure of your footing. Keep a firm hold on the handle and walk, never run. Slipping could cause injury.
9.DO NOT leave the machine unattended with the engine running.
10.Before cleaning, repairing or inspecting make certain engine has completely STOPPED. Disconnect and secure spark plug wire away from plug to prevent accidental starting.
11.DO NOT start or operate machine with debris bag zipper open.
OPERATION
(Continued From Previous Column)
12.Engine must be completely STOPPED before removing debris bag.
13.DO NOT operate machine without the entire debris bag and guards in place.
14.Slow down before turning.
15.Watch out for traffic when near or crossing roadways.
16.DO NOT operate engine in enclosed areas. Engine exhaust gases contain carbon monoxide, a deadly poison.
17.If vacuum inlet or discharge becomes plugged, STOP engine. Disconnect sparkplug wire and secure away from sparkplug. Use a stick to clear the plug when possible. If hands must be used to remove plug, always wear heavy gloves as the debris may be sharp.
MAINTENANCE AND STORAGE
1.DO NOT store machine or fuel container inside where fumes may reach an open flame, spark or pilot light such as in a water heater, furnace, clothes dryer or other gas appliance. Allow engine to cool before storing machine in an enclosure. Store fuel container out of reach of children in a well ventilated, unoccupied building.
2.Keep machine and engine free of grass, leaves or excess grease to reduce fire hazard and engine overheating.
3.When draining fuel tank, drain fuel into an approved container outdoors and away from open flame.
4.Keep all bolts, nuts and screws properly tight. Check that all cotter pins are in proper position.
5.Always provide adequate ventilation when running engine. Engine exhaust gases contain carbon monoxide, a deadly poison.
6.Service engine and make adjustments only when engine is stopped. Removed spark plug wire from spark plug and secure wire away from spark plug to prevent accidental starting.
7.DO NOT change engine governor speed settings or overspeed engine.
8.Check debris bag assembly frequently for wear or deterioration to avoid thrown objects and exposure to moving parts. Replace with new bag if loose seams or tears are evident. Replace bag adapter if worn, broken or cracked.
9.DO NOT test for spark by grounding spark plug next to spark plug hole; spark plug could ignite gas exiting engine.
10.Have machine serviced by an authorized dealer at least once a year and have the dealer install any new safety devices.
11.Use only genuine replacement parts purchased from your authorized dealer to assure that original standards are maintained.