To complete the set up of your Wireless Weather Station after the 15 minutes have passed please follow the steps that follow in the Detailed
DETAILED SET-UP GUIDE
I.BATTERY INSTALLATION (When one temperature sensor is being used)
1.First, insert the batteries to the temperature sensor (see “A. Remote Temperature Sensor” below).
2.Within 30 seconds of powering up the sensor, insert the batteries to the Weather Station (see “B. Wireless Weather Station” below). Once the batteries are in place, all segments of the LCD will light up briefly. Following the indoor temperature, and the time as 12:00 will be displayed. If they are not shown in LCD after 60 seconds, remove the batteries and wait for at least 60 seconds before reinserting them. Once the indoor data is displayed user may proceed to the next step.
3.After the batteries are inserted, the Weather Station will start receiving data signal from the sensor. The outdoor temperature should then be displayed on the Weather Station. If this does not happen after 2 minutes, the batteries will need to be removed from both units and reset from step 1 and the signal reception icon is no longer shown.
A.REMOTE TEMPERATURE SENSOR
1.Remove the mounting bracket. The bracket snaps on and off easily.
2.Remove the battery cover, by sliding the cover down.
3.Observing the correct polarity install 2 AA batteries. The batteries will fit tightly (to avoid
4.Replace the battery cover by sliding upwards. Be sure battery cover is on securely.
Battery Cover
B.WIRELESS WEATHER STATION
1.Remove the battery cover. To do this, insert a solid object in the space provided at the
2.Observe the correct polarity, and install 2 AA batteries.
3. Replace the battery cover.
Battery
Cover
Sensor signal reception icon*
5