Acu-Rite 973 instruction manual Preview the Display

Using the included LOW TEMPERATURE ADAPTOR

The wireless sensor will operate normally down to -4 ºF. Below -4 ºF, the electronics may operate erratically or become non-functional until the temperature raises again. In case temperatures fall below -4ºF, bring the wireless sensor indoors and use the included low temperature adaptor by running the wire out through a soft seal opening such as a window or door. When routing the wire for the low temperature adaptor, make certain that the wire will not be severed or damaged.

5 PREVIEW THE DISPLAY

Main Unit - Upper Display - Weather

Indoor Temperature	Outdoor Temperature	Wireless sensor channel Number
& Humidity	& Humidity	Weather Forecast

Wireless Sensor is

protected indoors in extreme temperatures

Wireless Sensor is

weather-resistant and can be placed outdoors

INDOOROUTDOOR

Minimum/ Maximum memory mode indicator

FORECAST

					Barometric
PRESSURE
0					Pressure at a
					given hour.
>+.24			+8	>
+.18			+6
+.12			+4
+.06			+2
0			0
-.06			- 2
-.12			- 4
-.18			- 6	>
> -.24	-12 -6 -3 -2 -1	0	- 8
inHg/Hr			Hr/hPa

NORMAL	EXTREMELY LOW	low-temp adaptor
		is used outside to
TEMPERATURES	TEMPERATURES	observe temperature

Graph shows air pressure history

Main Unit – Lower Display – Date and Clock

Moon Phase

MOON

Alarm has	Antenna is
been set
	receiving the
	time & date

INDOOR

LOW-TEMP.

ADAPTOR

OUTDOOR

EXTREMELY LOW TEMPERATURES

Month/

Date/

Day

N E D U I T N

O U E H R A U

M T W T F S S

REMOTE MAIN UNIT

Low Battery Indicators

signal

-4 ºF

OR LOWER

Wireless Sensor - Display

Press the “MODE” button inside the back of the wireless sensor to display temperature and/or humidity in one of three ways:

WIRELESS

SENSOR

LOW-TEMP.

SENSOR

NOTE: The wired TEMPERATURE ADAPTOR only observes temperature, not humidity. If the adaptor is placed outdoors, and the wireless sensor is indoors- the wireless sensor will only transmit the indoor humidity reading & the outdoor temp. reading.

4

1)Temperature continuously, 2)Humidity continuously, or

3)Temperature for 5 seconds, then humidity for 5 seconds NOTE: The sensor’s display setting does not affect the main unit’s display.

Channel							1	F
(sensor #)			press			press
	86.5		“mode”		25	“mode”	1	86.5
1			button	1		button
		F
								(Alternate icon)
Display Mode 1				Display Mode 2				25
(Temperature)					(Humidity)

Display Mode 3 (alternating temp. & Humidity)

5