Install Batteries Outdoor Sensor, Setup

SETUP

Extended periods of cold temperatures ( below -4ºF / -20ºC ) can cause

Press and hold the “SET” button to enter into setup mode. The time will

alkaline batteries to function improperly. This will cause the outdoor

begin blinking.

sensor to stop transmitting temperature readings. Use lithium batteries in

low temperature conditions to ensure continued operation for wireless

To adjust the currently selected (flashing) preference item, press the

sensors placed outdoors. NOTE: Rechargeable batteries are not

“ ” or “ ” buttons.

recommended due to higher operating voltages.

To save your adjustments, press the “SET” button again to move on to

adjusting the next preference. The preference set order is as follows:

CLOCK HOUR

CLOCK MINUTE

TEMPERATURE SCALE (ºF or ºC)

You will automatically exit SET MODE if no entries are changed for 30

Remove the battery

seconds. You may enter basic setup mode again at any time by

compartment cover.

pressing the “SET” button.

Install 2 fresh “AA”

batteries as shown here.

BATTERIES MUST BE

INSTALLED FOR THE

The display unit has a wireless signal reception icon near the outdoor

temperature display area. If there are a low number of “bars” present

in the icon, you may experience no temperature display ( “- -” ) or

inaccuracy. In either case, you may need to relocate one or both of the

units. If most or all 4 of the bars are present, wireless reception is good

and no action is required.