Acu-Rite 502 instruction manual Set a Weather Alarm, Silence a Sounding Alarm

Page 14

Set a Weather Alarm

1.Choose the weather category for which you wish to set an alarm by pressing the up or down arrow buttons until the category is displayed on the Selectable Category part of the display unit.

2.To program a value (only applies to alarms that require a value), press AND HOLD the “” button until the “SET” indicator appears in the area of the display labeled “ALARM” (left of the selected weather category) and the alarm setting flashes.

3.Adjust the alarm value by pressing the up or down arrow buttons.

4.Press the “” button to confirm a value.

5.Next, press the “” button to activate the alarm. The alarm ON indicator will highlight on the display.

Alarm is now programmed and turned on.

To set or adjust an alarm value:

Press and hold “”

To activate or deactivate an alarm:

Press “”

Silence a Sounding Alarm

The alarm sounds initially for a few minutes, then silences itself. The alarm then sounds every few minutes afterwards until one of the following happens:

1.“SNOOZE” - Press any button. Alarm silences, but sounds again if the alarm condition reoccurs.

2.Turn the alarm “OFF” - Deactivates the alarm.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Professional Weather Center Package Contents Unpacking InstructionsFeatures & Benefits Display Clock Outdoor Sensor Signal Strength Alarm On/Off Indicator Wind Speed Alarm On Indicator Average Wind SpeedStorm Alert Alarm On Indicator Weather Select Programmable Alarm Setting Alarm On/Off ButtonBack of Display Unit Install or Replace Batteries In-1 Sensor SetupSet the A-B-C Switch Remove Rain Gauge StabilizerInstall or Replace Backup Batteries optional Display Unit SetupPlug-in Power Adapter Set the Date Set the Time & DateSet the Time Select Measurement Units Display Unit Placement Placement for Maximum AccuracyImportant Placement Guidelines In-1 Sensor PlacementIn-1 Sensor Installation In-1 Sensor Installation GuidelinesBasic Setup is Complete Clear Data Collected During InstallationWeather Forecast Using the Professional Weather Center Learning ModeProgrammable Weather Alarms Barometric PressureSet a Weather Alarm Silence a Sounding AlarmReception TroubleshootingProblem Possible Solution Inaccurate forecastTemperature or Display Unit Care Care & MaintenanceCalibration Calibrate Temperature & Humidity In-1 Sensor CareCalibrate the Rain Gauge TipsSpecifications FCC InformationLimited One Year Warranty Customer SupportPage It’s More than Accurate, it’s
Top Page Image Contents