Acu-Rite 622 instruction manual Problem Possible Solution, Humidity

Page 14

Troubleshooting

Problem

Possible Solution

 

• Make sure both the display unit and 3-in-1 sensor are

 

placed away from any heat sources or vents (see page 9).

Inaccurate

• Make sure both units are positioned away from moisture

sources (see page 9).

temperature or

• Make sure 3-in-1 sensor is mounted at least 5 ft off of

humidity

the ground.

 

 

• Calibrate indoor and outdoor temperature and humidity

 

(see page 15).

 

• What is wind reading being compared to? Pro weather

 

stations are typically mounted at 30 ft high or more. Make

 

sure to compare data using a sensor positioned at the

Inaccurate wind

same mounting height.

• Check location of the sensor. Ensure it’s mounted a

readings

minimum of 5 ft in the air with no obstructions around it

 

(within several feet).

 

• Ensure wind cups are spinning freely. If they hesitate

 

or stop try lubricating with graphite powder or spray

 

lubricant.

 

 

 

• Check that the batteries are installed correctly.

Display screen

Batteries may need to be replaced.

• Reset the display by pressing and HOLDING the

not working

“CLEAR RECORD/RESET” button, located on the

 

back of the display unit in the battery compartment.

 

Date and time will need to be entered after a reset.

 

 

If your AcuRite product does not operate properly after trying the troubleshooting steps, visit www.AcuRite.com or call (877) 221-1252 for assistance.

14

Image 14
Contents Weather Center Package Contents Unpacking InstructionsB-C Switch not shown Features & BenefitsTemperature & Humidity Sensors Mounting BracketDisplay Unit Current Indoor Temperature Current Outdoor TemperatureSensor Low Battery Indicator Average Wind Speed Display Low Battery Indicator Current Indoor HumidityInstall or Replace Batteries IN-1 Sensor SetupSet the A-B-C Switch Display Unit Setup Plug Power Adapter into Electric OutletSet the Time, Date & Units Display Backlight SettingsTemperature Units ºF or ºC Pressure Units inHg or hPaDisplay Unit Placement Placement for Maximum AccuracyImportant Placement Guidelines In-1 Sensor PlacementBasic Setup is Complete In-1 Sensor Installation GuidelinesClear Data Collected During Installation Top or Side MountWeather Forecast Using The Weather Center Learning ModeMulti-Variable History Chart Wind SpeedToday’s High Month’s High All Time High Weather SelectReplay Historical Data Inaccurate forecast TroubleshootingPossible Solution Problem Possible Solution HumidityDisplay Unit Care Care & MaintenanceCalibration In-1 Sensor CareSpecifications FCC InformationLimited One Year Warranty Customer SupportPage Page It’s more than accurate, it’s