Cub Cadet 75 manual Lubricationguide

Page 24

Front Wheels

Mower Spindle

Bearings (3)

Rear Discharge

Mower

See Page 15.

Engine Crankcase See Page 13.

LUBRICATIONGUIDE

Afer Every 10 Hours of Operation -Continued

Use IH 251 H EP grease or equivalent No.2 multi-purpose lithium grease and apply one or two strokes of the lubricator to the greasefittings (one fitting on each front wheel).

Use IH 251 H EP grease or equivalent No.2 multi-purpose lithium grease and apply one or two strokes of the lubricator to the grease fittings (one fitting on each spindle). Center spindle can be greasedthrough lift handle slot.

After Every 25 Hours of Operation

While the engine is warm remove the drain plug and drain all the oil from the crankcase. To drain completely, raise the right side of the riding mower by placing a 4-inch to 6-inch block under the right rear wheel. After draining, replace the drain plug. Remove the crankcase oil filler cap and refill the crankcase with new oil up to the "FU LL" mark on the oil level gauge. Refer to the

"Lubrication Table" for proper quantity and viscosity to use.

Mower Spindle

Bearings (3)

Side Discharge

Mower

See Page15.

Check Change

Point of Lubrication

at

at

Hours Hours

Crankcase 5 25

Transmission and

Differential

Use IH 251H EP grease or equivalent No.2 multi-purpose

, lithium grease and apply one or two strokes of the lubricator to the grease fittings (one fitting on each spindle). Center spindle

, can be greased through lift handle slot.

 

Anticipated

Air

Temperature

 

+320 F.

+320

to

00 F.

Below 00 F.

32 oz.

I.H. No.1 @

I.H.

No.1 (!)

SAE-5Wor

Engine Oil

Engine

Oil

 

SAE-5W-20

qt.

SAE-30

SAE-10W

 

Factory sealed. See your ,. H. Dealer

22-

98761EngineAbove.

Image 24
Contents Page Page Page Page Engine running, as the mower could acciden Page Page Starting the Engine Stopping the EnginePage Page Adjustingand Operating Trees,etcHeight of CUT Page Page Adjust the mower proceedasfollows Adjustingand Operating Adjusting Mower Drive V-BEL TEngagethe mower clutch Adjustingand Operating Main Drive Belts Page Page Adjustingand Operating Adjustable Rear Axle Drive Chain Carburetor Adjustments Horsepower BatterySpark Plug OIL Foam AIR Cleaner HeadElectricalsystem Engine CoolingDuring Operating Do not run Engine in confined area such as After Every5 Hours of Operation SeePage13After Every 10 Hours of Operation Lubricationguide Page Page Page Page Page With