Cub Cadet 53AH8ST3050, 53AH8ST5050 service manual Suspension Seat

Page 7

G.Suspension Seat

1.This unit is equipped with a heavy-duty vinyl fabric-covered seat incorporating adjustable armrests, an adjustable seatback, an adjust- able fore/aft track, a weight/ride adjustable mechanical suspension system, and an Operator Presence Control (OPC).

2.An OPC in the form of a switch, is integrated into the seat bottom and is connected to the machine electrical system. The weight/ride adjustment lever is located on the right side of the seatback and incorporates three set- tings: light = 110 lbs, medium = 195 lbs, and heavy = 286 lbs. Lever up is light and down is heavy. Weight adjustment should be made without the operator sitting in the seat. The seatback recline adjustment is also on the right side between the seat back and seat bottom, and it provides up to 10 degrees.

3.The fore/aft single-locking adjustment tracks operate on roller-bearings for smooth and almost effortless operation. The lever for seat track actuation is near the right front corner of the seat bottom, and allows fore/aft adjust- ment of 4”.

4.The seat is attached to pivotal brackets, which allow the seat assembly to pivot for- ward onto the foot platform area.

Note: The seat base must be secured by properly latching to the frame, otherwise, the seat assembly could tilt forward. The Operator Presence Control must be connected to the electrical wiring harness.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Hydrostatic Zero-Turn Commercial Riding Mower Table of Contents Forward Safety Precautions General Safety OperationsGeneral Related to Fuel When MowingRelated to Batteries Operator Protection System TowingSuspension Seat Shield Missing Do not Operate Safety Decals and LabelsSpecifications Operating Instructions When MowingTo Mow Grass and Produce a Striped Pattern Safety Awareness when MowingCheck the fluid levels and tires Initial AdjustmentsZero Turn Break-In And Operating Pro- cedures Lubricate all fittings listed in the maintenance sectionOrientation Initial Operation Start the Engine Parking the Mower Maintenance ServiceCleaning your Deck Mower Cutting BladesRemoving the Mower Deck Mower DeckChanging a Blade Hydraulic Oil Specific Gravity Freezing Temp F Battery RemovalInstalling the Battery Electrical CircuitJump Starting TiresInflation Pressure BrakesHydraulic Oil Tank and Filter ScrewStorage To Put the Mower Back in ServiceMaintenance Schedule If Mower is so equipped OIL ChartEngine RPM Check and Adjustment High Speed Tracking AdjustmentDeck Center Anti-Scalp Roller Settings Deck Corner Ball Wheel Roller SettingsLap Bar Adjustment Deck leveling Procedure Wiring Diagram Gaugeslope Page U.S.A Canada
Top Page Image Contents