Service
Safe Handling Of Gasoline:
1.To avoid personal injury or property damage use extreme care in handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Serious personal injury can occur when gasoline is spilled on yourself or your clothes which can ignite. Wash your skin and change clothes immediately.
a.Use only an approved gasoline container.
b.Never fill containers inside a vehicle or on a truck or trailer bed with a plastic liner. Always place containers on the ground away from your vehicle before filling.
c.When practical, remove
d.Keep the nozzle in contact with the rim of the fuel tank or container opening at all times until fueling is complete. Do not use a nozzle
e.Extinguish all cigarettes, cigars, pipes and other sources of ignition.
f.Never fuel machine indoors.
g.Never remove gas cap or add fuel while the engine is hot or running. Allow engine to cool at least two minutes before refueling.
h.Never over fill fuel tank. Fill tank to no more than ½ inch below bottom of filler neck to allow space for fuel expansion.
i.Replace gasoline cap and tighten securely.
j.If gasoline is spilled, wipe it off the engine and equipment. Move unit to another area. Wait 5 minutes before starting the engine.
k.To reduce fire hazards, keep machine free of grass, leaves, or other debris
l.Never store the machine or fuel container inside where there is an open flame, spark or pilot light as on a water heater, space heater, furnace, clothes dryer or other gas appliances.
m.Allow a machine to cool at least 5 minutes before storing.
General Service:
1.Never run an engine indoors or in a poorly ventilated area. Engine exhaust contains carbon monoxide, an odorless, and deadly gas.
2.Before cleaning, repairing, or inspecting, make certain the blades and all moving parts have stopped. Disconnect the spark plug wire and ground against the engine to prevent unintended starting.
3.Periodically check to make sure the blades come to complete stop within approximately (5) five seconds after operating the blade disengagement control. If the blades do not stop within the this time frame, your unit should be serviced professionally by an authorized MTD service dealer.
4.Check parking brake frequently as it is subjected to wear during normal operation. Adjust and service as required.
5.Check the blades and engine mounting bolts at frequent intervals for proper tightness. Also, visually inspect blades for damage (e.g., excessive wear, bent, cracked) Replace the blades with the original equipment manufacturer’s (O.E.M.) blades only, listed in this manual. “Use of parts which do not meet the original equipment specifications may lead to improper performance and compromise safety!”
6.Mower blades are sharp. Wrap the blade or wear gloves, and use extra caution when servicing them.
7.Keep all nuts, bolts, and screws tight to be sure the equipment is in safe working condition.
8.Never tamper with the safety interlock system or other safety devices. Check their proper operation regularly.
9.After striking a foreign object, stop the engine, disconnect the spark plug wire(s) and ground against the engine. Thoroughly inspect the machine for any damage. Repair the damage before starting and operating.
10.Never attempt to make adjustments or repairs to the machine while the engine is running.
11.Grass catcher components and the discharge cover are subject to wear and damage which could expose moving parts or allow objects to be thrown. For safety protection, frequently check components and replace immediately with original equipment manufacturer’s (O.E.M.) parts only, listed in this manual. “Use of parts which do not meet the original equipment specifications may lead to improper performance and compromise safety!”
12.Do not change the engine governor settings or
13.Maintain or replace safety and instruction labels, as necessary.
14.Observe proper disposal laws and regulations for gas, oil, etc. to protect the environment.
WARNING: Your Responsibility: Restrict the use of this power machine to persons who read, understand and follow the warnings and instructions in this manual and on the machine.
5