Parking Brake Adjustment, Steering Adjustment

Parking Brake Adjustment

WARNING: Never attempt to adjust the brakes while the engine is running. Always disengage PTO, stop engine and remove key to prevent unintended starting.

If the tractor does not come to a complete stop when the brake pedal is completely depressed, or if the tractor’s rear wheels can roll with the parking brake applied, the brake is in need of adjustment. The brake disc can be found on the right side of the transmission in the rear of the tractor. Adjust if necessary as follows.

•Looking at the transmission from the right side of the tractor, locate the compression spring and brake disc. See Figure 11.

Brake Rod

Crown Nut

Brake Disc

NOTE: View shown from beneath tractor.

Figure 11

•Carefully remove the cotter pin from the crown nut on the right side of the brake assembly.

•Using a feeler gauge, check the gap between the brake disc and the brake puck. Proper gap is .011".

•Tighten the crown nut until the proper gap is achieved.

•Insert a replacement cotter pin (part # 714-0111) into the crown nut.

Steering Adjustment

If the tractor turns tighter in one direction than the other, or if the ball joints are being replaced due to damage or wear, the steering drag links may need to be adjusted.

Adjust the drag links so that equal lengths are threaded into the ball joint on the left side and the ball joint on the right side:

•Loosen the jam nut found on the drag link at the rear of the ball joint. See Figure 12.

•Remove the hex nut and lock washer on the top of ball joint. See Figure 12.

Hex Nut and

Lock Washer

Pivot Bar

Axle

Jam Nut

Ball Joint

Figure 12

•Thread the ball joint toward the jam nut to shorten the drag link. Thread the ball joint away from the jam nut to lengthen the drag link.

•Replace hex nut and lock washer and retighten the jam nut after proper adjustment is achieved.

NOTE: Threading the ball joints too far onto the drag links will cause the front tires to "toe-in" too far. Proper toe-in is between 1/16" and 5/16".

Front tire toe-in can be measured as follows:

•Place the steering wheel in position for straight ahead travel.

•In front of the axle, measure the distance horizontally from the inside of the left rim to the inside of the right rim. Note the distance.

•Behind the axle, measure the distance horizontally from the inside of the left rim to the inside of the right rim. Note the distance.

•The measurement taken in front of the axle should be between 1/16" and 5/16" less than the measurement taken behind the axle.

•Adjust if necessary.

Seat Adjustment

WARNING: Before operating this machine, make sure the seat is engaged in the seat stop, stand behind the machine and pull back on seat until fully engaged into stop.

To adjust the position of the seat, move the seat adjustment lever (Refer to Figure 1 on Page 9) to the left and slide the seat forward or rearward. Make sure seat is locked into position before operating the tractor.