Switch PCBA
Wire Trap #3
= WIRE TRAPS or GUIDES
Channel in | |
Lower Motor |
|
Support for |
|
red motor wire | Main PCBA |
| |
| Rubber lugs |
Rubber | Motor |
lugs |
|
| Battery Terminal |
| Block |
AS AN AID TO REASSEMBLY, TAKE NOTICE OF WIRE ROUTING AND POSITION IN WIRE GUIDES AND TRAPS WHILE DISMANTLING TOOL.
BE CAREFUL AND AVOID PINCHING WIRES BETWEEN HANDLE HALVES WHEN ASSEMBLING.
| Channel in Lower Motor |
Rubber lugs | Support for black motor wire |
|
#2 Handle/Motor |
Housing Halve |
#13 Lower |
Motor Support |
#14 Motor |
#15 Upper |
Motor Support |
When reinstalling a new Motor Assembly, be sure that the red and black motor leads are fed through the large opening in the back of the Lower Motor Support before soldering wires to the
Slide the lower motor support onto the rear of the motor, orienting it as shown and making sure it is firmly pressed into place.
Be sure that the Upper Motor Support is oriented as shown and firmly seated on the spindle end of the Motor.
Press the motor leads into the channels of the lower motor support and remove most of the slack from the rear of the motor. Line up the rubber lugs of the upper and lower motor supports with the channels in the motor cavity of the Handle/ Motor Housing Halve. Install the assembly into the handle/motor housing halve.
NOTE:
For ease of installation, the upper motor support can be left off the spindle end of the motor until the lower motor support and motor are pressed into place. At that time, the upper motor support can be assembled onto the motor, orienting the rubber lugs with the corresponding channels in the motor cavity and firmly seated.