FEATURES
INSTRUCTIONS
When unpacking the blower:
■Carefully remove the blower and accessories from the box.
■Make sure that all items listed in the packing list are in- cluded.
■Inspect the blower carefully to make sure no breakage or damage occurred during shipping.
■Do not discard the packing material until you have care- fully inspected and satisfactorily operated the blower.
■If any parts are damaged or missing, please call
WARNING:
If any parts are missing do not operate the blower until the missing parts are replaced. Failure to do so could result in possible serious personal injury.
PACKING LIST
Blower
Upper Blower Tube
Wide Sweeper Nozzle
Tube Clamp
Operator's Manual
NOTE: Read and remove all hang tags and store with your operator's manual.
ASSEMBLY
WARNING: | WING NUT |
|
Stop the engine and disconnect the spark plug wire before installing parts, making adjustments, cleaning, or when not in use. Failure to do so could result in possible serious personal injury.
ASSEMBLING THE BLOWER TUBES
NOZZLE | UPPER TUBE |
See Figure 2.
1. Screw the nozzle onto the upper blower tube and tighten
securely. Check tightness after initial run and retighten ifFig. 2 needed.
2.Place clamp around the neck of the blower housing outlet. Do not tighten the wing nut yet.
3.Align the locking tab on upper blower tube with the slot in the blower housing outlet; push the tube into the housing. Twist to lock into place.
4.Rotate the tube so the nozzle is pointing upward as shown. Tighten the wing nut securely. See Figure 2.
5.To remove the tubes, loosen the wing nut on the clamp. Rotate the tubes to unlock them remove from the blower housing outlet.
Page 7