Black & Decker CP120XB Troubleshooting Guide, Common Power Output Problems 115 Volt AC

Page 11

TROUBLESHOOTING GUIDE

Common Power Output Problems – 115 Volt AC

Possible Cause

Red battery status LED indicator is flashing and there is no output

Recommendations

Unit is in charging mode. For optimum results, allow unit to complete charging cycle before using.

Battery Status LED indicators are all lit, but there is no output

Charging is complete, disconnect charging adapter from unit and wall receptacle. Wait 5 minutes before using inverter.

Inverter sudden shutdown, Inverter Status LED is lit red

and green Battery Status LEDs are lit

Inverter Status LED is lit red

and green Battery Status LEDs are lit, but there is no AC power

LED indicators are off,

unit may not be in the ON position

Unit shuts down after a few minutes, internal battery voltage is low

Overload condition, reduce load to a maximum of 16 watts and attempt a manual reset

Unit shutdown from overload or fault condition, attempt manual reset and reduce load

Hold ON/OFF pushbutton for at least 1 second to turn unit ON

Internal battery pack needs recharging, refer to charging instructions on page 7

Common Power Output Problems – USB Outlet

Possible Cause

Recommendations

No power from USB port

Hold ON/OFF Pushbutton for at least 1

 

second to turn unit on.

Device connected to USB port

Be sure device can be charged through

is not charging

USB Port and current draw is not larger

 

than 350 mA

For assistance with your product, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK & DECKER help line at 1-800-544-6986.

10

Image 11
Contents Before Returning this Product for ANY Reason Please Call Power to GORead ALL Instructions Safety Guidelines / Definitions Important Safety Instructions Page Introduction FeaturesVolt AC Output HOW the Power to GO WorksPower to GO Inverter Output Waveform Operating Instructions Inverter monitors the following conditions Protective FeaturesPower to GO should only be operated in locations that are Operating TipsTroubleshooting Care and MaintenanceCommon Power Output Problems 115 Volt AC Troubleshooting GuideFull Two-Year Home Use Warranty AccessoriesService Information USB Output DC 350mA Batteries AH NiMH SpecificationsInput DC, 5.0A Inverter Output Watts continuous