Generac 1537-0 owner manual How to Use Accessory Tray, Items as optional accessories

GeneracPortableProducts2,400PSIHighPressureWasher

•Return the starter grip handle slowly. Do Not let rope "snap back" againststarter.

•When engine starts, slowly move choke lever to the "Open" position. If engine falters, move choke lever to the "Closed" position, then to the "Open" position.

•If engine fails to start after six pulls, move choke lever to the "Open" position. If engine fires, but does not continue to run, move choke lever to the "Closed"

position, then to the "Open" position.

NOTE: If the recoil starter ishard to pull, it maybe necessary to squeezethe gun trigger to relieve internal pump pressure.

How to Stop Your Pressure Washer

•Move throttle lever on engine to "Stop" position.

•Rotate the fuel valve lever to the "Off" position.

•Squeeze trigger on the spray gun to relieve pressure in the hose.

NOTE: A small amount of water will squirt out when you release the pressure.

How to Use Accessory Tray

The unit is equipped with an accessory tray with placesto store your nozzle extension, and slots to hold the cleaning solution bottle and the detergent siphoning filter. There are also two hooks on the handle to hold your spray gun and high pressure hose.

NOTE: The extra holes in the tray are for storing a brush and a turbo wand. The brush and turbo wand are NOT

included with your pressure washer. You can buy these

items as optional accessories.

•Hang your chemical solution bottle on the "J"hook and place the detergent siphoning filter in the last slot on the left (Figure 15).

•Hang the high pressure hose on the hook attached to the handle on the right side of the unit (Figure 15).

•Place the spray gun on the hook attached to the handle on the left side of the unit as shown on page4.

How to Use the Adjustable Nozzle

You now should know how to START your pressure washer and how to STOP it. The informationin this

section witl tell you how to adjust the spray pattern and apply detergent or other cleaning chemicals.

_ DANGER! Never adjust spray pattern when spraying. Never put hands in front of nozzle to

adjust spray pattern.

The adjustable nozzle affixed to the nozzle extension permits you to adjust the spray pattern and the spray pressure, as follows:

•Slide the nozzle forward to adjust the spray to low pressure mode (Figure 16). Slidethe nozzle backward to achieve high pressure.

•Placethe nozzle extension through the hole on the accessory tray as shown in Figure 15.

Slide nozzle backward

for high pressure mode.

Slide nozzle forward for

low pressure mode and detergent application.

/

9