Grundig 2245 manual Trigger Safety Latch, Installing and Changing Spray Tips

Page 7

Trigger Safety Latch

WARNING

To reduce the risk of serious bodily injury, including fluid injection, splashing in the eyes or on the skin, ALWAYS engage the trigger safety latch whenever spraying stops, even for a moment.

In the engaged position, the trigger safety latch prevents the gun from being triggered accidentally by hand or if it is dropped or bumped. Be sure the latch is pushed fully down when engaging it or it cannot prevent the gun from being triggered. See Figure 2.

TRIGGER SAFETY

LATCH

SHOWN ENGAGED

TRIGGER SAFETY LATCH SHOWN DISENGAGED

Figure

2

Installing and Changing Spray Tips

WARNING

To reduce the risk of serious bodily injury, including fluid injection or splashing in the eyes or onto the skin, use extreme caution when changing spray tips. ALWAYS follow the procedure below.

1.Follow the Pressure Relief Procedure.

2.Point the gun and wand away from yourself and anyone else.

3.Without holding your hand over the spray tip (A), pull back the quick coupler ring (B). Remove the old tip and/or install a new one, and then release the ring. See Figure 3.

4.Be sure the tip is secure before starting to spray again.

5.Tip holding holes are provided on the chassis.

CAUTION

To avoid blowing the o±ring out of the quick coupler, due to the high pressure in the system, never operate the pressure washer without a tip securely mounted in the quick coupler.

A

B

Figure 3

￿08-￿89￿ ￿ ￿ ￿ ￿ 7

Image 7
Contents INSTRUCTIONS-PARTS List Medical Treatment General SafetyPressure Relief Procedure Spray Gun Safety DevicesSystem Pressure Hose SafetyEquipment Misuse Hazard Fuel and Emission HazardsTerms Moving Parts HazardConnect to Water Supply InstallationSet Up Check for Shipping DamageStartup Installing and Changing Spray Tips Trigger Safety LatchPressure Relief Procedure MaintenanceSHUTDOWN, Flushing and Storage Problem Troubleshooting ChartParts Drawing 800±062 & 800±063 Hydra±Cleanr 2245 Pressure WasherPart Description QTY Parts List800±065 Hydra±Cleanr 3035 Pressure Washer 801±003 BELT, Drive 801±539 800±335 Hydra±Cleanr 3040 Pressure Washer 800±393 GUN & Wand Assembly Page Part REF Part Description QTY NO. no Valve AssemblyServicing the Plungers Pump ServiceValves Pumping SectionTechnical Data AccessoriesServicing the V±Packings Graco INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440±1441 Graco Warranty